Because your multimeter is not an adequate device for this kind of measurement. Use the correct multimeter to display the triangular wave value.
A sine wave has no harmonics. It only has a fundamental, so the value of the 2nd, 3rd, and 12th harmonics of a sine wave is zero.
When a low pass filter is used with a sine wave input, the output is also a sine wave. The output will be reduced in amplitude and phase shifted when the frequency is high, but it is still a sine wave. This is not the case for square or triangular wave inputs. For non-sinusoidal inputs the circuit is called an integrator.
The magnitude of a sine wave can be calculated using its amplitude, which is the peak value of the wave. For a sine wave represented by the equation ( y(t) = A \sin(ωt + φ) ), the magnitude is simply the absolute value of the amplitude ( A ). If needed, the root mean square (RMS) value can also be derived from the amplitude, calculated as ( \text{RMS} = \frac{A}{\sqrt{2}} ).
Using its Taylor-series.
For a standard 360 deg sine wave with starting point of 0 deg, peaks will occur at 90 deg and 270 deg.
A square wave will have the highest value since it has a peak, positive or negative, all of the time. Other wave shapes such as triangular and sine, have a lower value than this.
rms values refer to "root mean square" mathematical values of the sine wave of electricity. This is essentially an "average" value of the voltage being measured as voltage in any circuit varies constantly.
Sine 3.3 degrees is about 0.057564. Sine 3.3 radians is about -0.157746. Sine 3.3 grads is about 0.051813.
Depend the value of capacitor. Capacitance in series act like a high pass filter, while in parallel act like low pass filter. By fourier series, triangular wave is combine of series of the sine or cosine waves. Therefore by certain capacitance, sine wave can preduce by applied a triangular signal through a capacitor. Current is just 90 degree shift from voltage, shape is same.
The sine of 180 degrees is 0. Remember, the sine value on a unit circle is the y-value. If you find f(pi) in the function f(x)=sin(x), you will get zero as an answer.
If you look at the definition of the sine function in a triangle, you'll discover that the maximum possible value of the sine function is ' 1 ' and the minimum possible value is ' -1 '. There's no angle that can have a sine greater than ' 1 ' or less than ' -1 '. So the absolute value of the sine of anything is always ' 1 ' or less.
it is DC powered, but can generate sawtooth or triangular wave AC if wired up properly. it cannot generate sine wave AC, although with an opamp wave shaping circuit the triangular AC waveform can be reshaped to a rough approximation of a sine wave.
sine(15 degrees) = 0.25882 (rounded)
sine of 30 degrees
One. Exactly one.
The sine of an angle can never equal 2 because the sine function, defined as the ratio of the length of the opposite side to the hypotenuse in a right triangle, has a range of values between -1 and 1. This means that for any angle, the sine value will always fall within this interval, making it impossible for sine to equal 2. Therefore, there are no angles for which the sine function outputs a value of 2.
The exact value is 0.5*sqrt(3)