The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
pull the toilet. Make sure the trap is clear on the toilet, and then snake the toilet line.
either the vert is plugged and there is no air getting through or there is no vent at all
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
Drain line clogged. Toilet itself may be problem.
The main drain is plugged. You may need to remove the toilet and snake directly down the drain.
Drain it into a toilet and flush it
Water runs in the toilet bowl to maintain proper water levels and to flush waste down the drain when the toilet is flushed.
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
A toilet may swirl but not flush properly due to a clog in the drain pipe, insufficient water in the tank, or a malfunctioning flapper valve.
To drain a toilet properly, turn off the water supply valve located behind the toilet. Flush the toilet to remove most of the water. Use a plunger to push any remaining water down the drain. You can also use a wet/dry vacuum to remove water if needed.
Water drains from the toilet bowl after flushing because the force of the flush pushes the water down the drain pipe, creating a suction effect that pulls the water out of the bowl.
To completely drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. You can also use a wet/dry vacuum to suction out any remaining water.
Do the rest of the fixtures in the bathroom drain well? If they do not drain well, my guess would be the venting of the plumbing system. If all of the other fixtures in the bathroom drain well, then there is probably something in the trapway of the toilet. Assuming it is just the toilet that is having problems, then a closet auger might do the trick. Hope it helps.
pull the toilet. Make sure the trap is clear on the toilet, and then snake the toilet line.
To fully drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. Finally, use a wet/dry vacuum to suction out any remaining water in the bowl and tank.
To fix a toilet that won't flush, you can try checking the water level in the tank, adjusting the flapper or chain, clearing any clogs in the drain, or replacing the fill valve or flush handle if necessary.