A CT is used to measure current, and is NOT referenced to ground, and has very low primary impedance. A PT is used to measure voltage, is referenced to ground, and has a much higher impedance (since it is referenced to ground).
The difference in between Ohms and Ohms CT is that in Ohms CT it has CT at the end.
It means Current Transformer is used for measurement of electric currents, together with voltage transformers
'CT' is used to designate current transformers, and 'PT' is used to designate potential transformers. A current transformer provides a ratio of primary current to the secondary. A potential transformer provides a ratio of primary voltage to the secondary. A power transformer (step up or step down) resembles a PT more than a CT.
This can be done, but is usually not done because a metering CT is made to be very accurate at expected load current levels. A protection CT is made to be accurate at fault current levels (which is often significantly above load current). If the CT is too small, and has too small of a ratio, the CT will likely saturate, which will skew the results the protective device expects to get. An example: a metering CT may have a ratio of 100:5 (made for 100A load current, which will produce 5 amps secondary current). Fault current levels may be ~10,000A. You'd expect the secondary output of a perfectly linear CT to be 500A. One way resistance of the cable connecting the protective device to the CT may be on the order of .5 - 2 ohms. Ignoring the resistance of the CT and connected devices, secondary voltages would reach 250 - 1,000 volts for a phase fault, and 500 - 2,000 volts for a ground fault. The biggest CTs may be rated for 800 volts output below the knee point, so this 100:5 CT would clearly saturate. The real output current would likely be on the order of 150A at the most. ...And the above is ignoring any DC offset, which would cause the CT to saturate at unpredictable AC current levels.
The address of the Cheney Hall Foundation is: , Manchester, CT 06040-5922
Side effect of cervical ct scan?
5P20 CT give more accuracy than PS class CT. 5P20 cant be used in unit protection. Class PS CT is a protection class ct. It is used for differtial proction,distance (UNIT)proction.
The ray used in CT scans is X-Ray!!!
The address of the Indiana Basketball Hall Of Fame Foundat is: 1 Hall Of Fame Ct, New Castle, IN 47362-2941
X-Ray machine,CT(computed tomography)... are used in cancer hospitals for taking the image of cancer tumor,by the principle of PHOTO ELECTRIC effect.
ct of carbon dioxide on limewater
in old saybrook , CT behind town hall on main street
The address of the Alaska Sports Hall Of Fame is: 6740 Samuel Ct, Anchorage, AK 99516-6908
The address of the Academy Hall Museum is: 785 Old Main Street, Rocky Hill, CT 06067
The address of the Americas People Hall Of Fame is: 2535 Kenmont Ct, Beavercreek, OH 45434-7001
The address of the Southeast Connecticut Hall Of Fame is: 10 Sandy Hollow Dr, Waterford, CT 06320-2600