0
What else can I help you with?
Why are taps made of metal?
Taps need not be made with metal.... But most taps are because they don't melt if hot water passes through............
Why is there No hot water coming from taps and no pressure in combi boiler?
If there is no hot water coming from the taps and no pressure in a combi boiler, it could be due to several issues. A common reason is low water pressure, which may be caused by a leak in the system or a faulty pressure relief valve. Additionally, the boiler could be in lockout mode due to overheating or a fault, preventing it from heating water. Checking the pressure gauge and ensuring it’s within the recommended range, along with inspecting for leaks, can help diagnose the problem.
How can you fix plumbing when the upstairs hot water in the shower turns off when the taps or shower downstairs are running?
Not knowing the age/size/configuration of your plumbing or it's condition, I can only suggest what might be causes for your situation. . Your pipes are old and the interior of the pipes have become narrowed by rust or corrosion.(over time sediments collect on the interior of your pipes and severely restrict the flow(volume). The older the plumbing the more chance this has happened) . Your water supply pressure is too low. . A restiction in the shower head/diverter. . Corroded valves in the shower.(not fully opening) . Supply lines are to small to handle all the fixtures at one time. . Main supply line valve not open all the way. There is a multitude of things that could cause this situation. Start by: .Taking off the showerhead. Turn on the valves, hot and cold, test one at a time, and see it there is sufficient water coming to the shower when the valves(upstairs and downstairs) are both open. This will identify if there is enough water coming up to the shower and if it is just in one side.(hot or cold) If there is sufficient water flow: Clean or replace the shower head. If not: . Check the sink/toilet water flow and see if they slow or stop running when the downstairs shower is running. If they too slow considerably, it is probably a problem common to the supply line to the upstairs. . Check your water lines(hot or cold) feeding the upstairs shower to see if it is large enough and tied into a line large enough to carry the demand. You can also: . Test the water pressure as near to the Main suppy line as possible.(outside hose bib) You can get a gauge to screw onto a hose nozzle for a few dollars at the hardware store. Unless you have a Water Pressure regulator in line with the Main Valve, the water pressure should be the same at all outlets. If you do have a regulator, the "presuure"(not volume) may be reduced after the Regulator but shold still be at a new equal pressure throughout the house. note:(Water Pressure Regulators help protect your fixtures from excessive pressure and surges. High pressure could cause leaks or failure of some units.) The gauge may help you identify where a restriction may be located. If the upstairs shower was added during a remodel, it's possible the supply lines were not properly designed to handle the extra water demand. This would require some plumbing renovation to bring it up to specs. As a general note: Old 3/4" galvanized pipes after time can restrict down to pencil size or smaller inside. Even plug off completely. You know what that will mean... Good Luck.
How does water come to our taps?
Water reaches our taps through a system of sources, treatment facilities, and distribution networks. It typically begins at natural sources like rivers, lakes, or underground aquifers, where it is collected. The water is then treated at a facility to remove contaminants and ensure safety. Finally, it travels through a network of pipes before arriving at our taps for use.
Does water flow from hot to cold?
No, cold water is piped into the hot water tank and is heated by electricity or gas, it then flows out to the hot water taps.
Why the bucket is filled faster in the downstairs tap than in upstair tap?
Assuming the taps are physically identical and the pipes leading to each tap are of a consistent size as well (and that the two are both fed directly from the same main with no intermediate plumbing weirdness), the downstairs tap should have a (slightly) higher water pressure. Each foot of difference in height between the two taps will make a difference of a bit over two-fifths of a pound per square inch of water pressure.
Why is there no water coming out of any taps in the house?
There may be no water coming out of the taps in the house due to a water main break, a plumbing issue, or a problem with the water supply. It is important to check with the water company or a plumber to determine the cause and address the issue.
If water faucets upstairs and downstairs are turned fully on?
If water faucets upstairs and downstairs are turned fully on, you would be wasting a lot of water. Each faucet delivers about 3gpm under normal use. this kind of use would lower that figure considerably. If there was some kind of question involved here, it wasn't very apparent.
Why in a multistory building the pressure of water in the taps coming from the overhead tank at the ground floor houses is more than that of taps in the fourth and fifth floor houses?
A lack of pressure to push the water up.
Why do some people have hard water coming out of their taps and some people have soft water?
depends on the bedrock and soil type where the water comes from.
Why filling a bucket from downstairs tap fills faster?
The larger the height difference between a point in a liquid and its surface (AKA the deeper it is), the more the pressure exerted at that point. To make it easy to visualize, imagine you are in a swimming pool. You get a feeling of being squeezed when you are under the water. The deeper you get (that is, the further you are from the surface), the stronger that squeeze is. That squeeze you feel is pressure. Whatever your setup is, whether you take the water from the city main pipeline or you have your own water tank or water pump, the idea is the same. The downstairs tap is "deeper" than the upstairs tap, i.e. it experiences more pressure. Since the larger pressure means a larger force, the water in the downstairs tap experiences a larger force, so more water can come out of that tap.
What causes the hot and cold taps upstairs to have no water pressure and all toilets gurgle and sputter and the pressure is slow?
This issue could be caused by a blockage in the water supply line, a malfunctioning pressure reducing valve, air trapped in the pipes, or a problem with the water heater. It is recommended to contact a plumber to diagnose and fix the problem.
What are the signs of a failing water heater?
Signs of a failing water heater include insufficient hot water, strange noises coming from the unit, leaks or puddles around the water heater, and rusty or discolored water coming from the taps.
What are the signs that indicate a water heater is going out?
Signs that indicate a water heater is going out include: water not heating up properly, strange noises coming from the heater, leaks around the unit, and rust-colored water coming out of the taps.
I have a power shower upstairs it turns on but no water is coming out there is a red light that says 'low pressure' but all the other taps and showers are running fine please help?
some power showers have to work of he main supply ,if u you try them run them off grvity the presure is no enough so they wont work
Does the water in the loft water tank reach the drinking taps or is it only for heating?
That water is used in the cold taps in your bathroom and for the heated water you use. Don't drink from these taps.
No cold water because of a burst pipe outside the house can I still use the hot water taps inside?
No, the cold water supplies the water heater also. No water coming in means no water at all.
