Wonder board is a cement board that is very firm. Unlike wood it doesn't warp or rot. It is especially used as the underlayment for tile floors and shower walls.
Your new floor will only be as good as the subfloor it goes over. New underlayment doesn't have wax, cracks, stains, rot or anything that is the reason you are replacing it, and it is smooth & provides a good surface for adhesion... the process of removing the old unearths bad subfloor conditions very often that would have compromised your new floor , so it is also part of a good process too...
basalt, marble
Not really a good idea. The water over time from the concrete will cause the board damage. If you use a good pad there is no reason you cannot lay the carpet over concrete.
You shouldn't. You need a surface that will allow the adhesive to make a good bond to. There are different types, read the instructions for the one you buy and apply it to the recommended sub floor.
That depends entirely on what the finished floor is going to made of. If it's 'click' laminate then wavy thin foam sheet is best. If good quality lino then thin plywood is best , etc.
The best hardwood floor underlayment for optimal installation is typically a high-quality foam or cork underlayment. These materials provide good cushioning, sound insulation, and moisture protection for the hardwood flooring.
This is not a good idea without using a cement /mortar board underlayment.
Your new floor will only be as good as the subfloor it goes over. New underlayment doesn't have wax, cracks, stains, rot or anything that is the reason you are replacing it, and it is smooth & provides a good surface for adhesion... the process of removing the old unearths bad subfloor conditions very often that would have compromised your new floor , so it is also part of a good process too...
if the old floor is down good and tight, you can go right over it. If it has a strong embossed pattern it may telegraph through the new floor though. you can skim coat over that if you need to.
The thin set under the board is to fill in any low spots in the floor. It is not to adhere the board to the floor. It is preventative against deflection. If there is a low spot and you do not fill it in, the board will flex and the grout/ tile will crack. Do not use construction adhesive it will do more harm then good.
Backer board and cement board are both used as underlayment for tile installations, but they have some differences. Backer board is made of a combination of cement and wood fibers, while cement board is made of cement and reinforced with fiberglass mesh. Cement board is more durable and water-resistant, making it suitable for wet areas like bathrooms and kitchens. Backer board is lighter and easier to cut, making it a good choice for smaller projects or areas with less moisture exposure. Consider the specific needs of your project to determine which material is more suitable.
Insulayment is good for most any type of flooring, other than tile.
In my opinion, no it will swell.In my opinion, yes you can install laminate over tile if the tile is in good condition/stable and even. You would first put underlayment above the tile and then the laminate on top. (you always add underlayment before laminate). It is important, though, to make sure you have enough clearance for the doors (you may need to shave the doors). If it's a kitchen, you also want to make sure there is enough clearance for the appliances.
Stevie Wonder was good
Good-bye - The Wonder Years - was created on 1990-04-24.
You cannot sand and finish particle board floors with polyurethane. Particle board does not have a finish that would allow any liquid to be put on it. It would disintegrate. Particle board is not a good flooring material.
I wonder who wrote the Book of Love. This garden path always awakens my sense of wonder.