0
Positive direct current (DC) is not used in electrostatic precipitators (ESPs) primarily because it can lead to the charging of particles in a way that promotes their re-entrainment into the gas stream after collection. Instead, negative DC is employed, as it effectively attracts positively charged particles to the negatively charged plates, enhancing particle capture efficiency. Additionally, using negative DC reduces the likelihood of back corona discharge, which can compromise the ESP's performance.
What else can I help you with?
What will happen to DC signal if positive probe connected to negative terminal and negative probe connected to positive of DC supply oscilloscope?
If the positive probe of the oscilloscope is connected to the negative terminal and the negative probe is connected to the positive terminal of a DC supply, the oscilloscope will display an inverted signal. This means that the voltage reading will be negative, effectively showing the opposite polarity of the actual DC voltage. The magnitude of the reading will remain the same, but the trace on the oscilloscope will appear flipped around the zero voltage line.
How does single phase alternator differ form a dc ganerator?
Single phase alters from positive to negative at 50 (50hz) or 60 (60hz) times per minute. While in dc it does not vary but stays at a constant positive phase.
4 what is the name of the circuit that adds a positive or negative dc voltage to an input sine wave?
This DC voltage is called the DC offset. Any decent signal generator will be able to add DC offset to the signal it generates. If you don't have one, simply connect a DC voltage to your signal.
Where would DC be used instead of AC?
DC is used for extra-high voltage transmission systems, as there are less losses with DC than with AC, and no synchronising problems.
What device used to increase or decrease DC voltage?
A DC-to-DC converter is the general term for a device that changes DC voltage at one level to another.
What is the major difference between a bipolar an unipolar dc?
Bipolar dc involves both majority carrier and minority carriers for conduction while unipolar requires only majority carriers or minority carriers during conduction. point of view based on electronics devices.
Is 9v dc in positive or negative?
A 9V DC (direct current) supply can be either positive or negative, depending on how it is configured. Typically, in most applications, a 9V DC source is positive, meaning the positive terminal has a higher voltage relative to the negative terminal. However, if the terminals are reversed, it can be considered a negative 9V DC. The designation of positive or negative is determined by the polarity of the voltage applied.
What color is green positive or negative for DC?
green is ground regardless of ac or dc
In dc electric Which wire is positive?
Brown
What color usually represents positive in electricity?
If it is DC then red is positive and black is negative.
Difference between general English and esp?
general English is used as a universal language, and ESP is an English used in a specific purpose or in a specific fields.
How do you get -48v DC?
In a 48V DC system you ground the positive to 0V so the live wire will be -48V.
Trans former can not run with ac why?
It does A transformer is an electrical device used to convert AC power at a certain voltage level to AC power at a different voltage, but at the same frequency. Normal supply DC (Direct Current) won't work without some changes to how it travels. The DC is turned on and off quickly in the primary coil, and this action will allow the pulsating that DC in the primary to drive the secondary transformer. Remember AC alternated between a positive currect and a negative current where Dc is positive then drops to zero then back to positive
Why are there positive and negative wires when stimulating nerves?
The most likely explanation is that the equipment used to stimulate the nerves uses a DC voltage to do so.
What polarity should be used for 7018 rod?
7018 electrodes should be used with DC positive polarity. This means the electrode holder is connected to the positive terminal of the welding machine, resulting in better arc stability and smoother weld deposits.
What is a rectifier diodes?
It's an electronic component used to turn AC into DC. But it'won't be pure DC w/o some further processing. It is basically a semiconductor meaning will pass current one way only. Electrons will flow from positive to negative. Therefore Direct Current or DC as opposed to AC alternating current meaning positive and negative current flow. there is no such a thing as pure DC by adding a capacitor it can approach pure DC but mathematically speaking it is impossible to achieve.
What country has the abbreviation of ESP?
The country with the abbreviation ESP is Spain. This abbreviation is commonly used in international sports and other contexts to refer to Spain.
