A resistor.
A cement resistor is typically used as a power resistor (a resistor whose power rating is greater than 1 W).
Which type of resistor is commonly used in automotive circuits?
A typical resistor will burn out when it dissipates power in excess of double its power dissipation rating for an extended period of time. The power dissipated by a resistor is equal to I2R or E2/R, where E = the voltage across the resistor I = the current through the resistor R = the resistance of the resistor
This is usually a resistance wire wound resistor that has a physical connection on the body of the resistor called a tap. It about the same as tapping a water line to attached a hose line to your icemaker.
The range of resistor value typically used in water level detectors is between 1k ohm to 100k ohm. The specific resistor value depends on the sensitivity required for detecting the water level change. It's important to choose the resistor value that provides a balance between sensitivity and stability in the detector circuit.
In some circumstances a filament bulb is used as a variable resistor. As the filament heats up, its resistance increases. This effect is used in some automatic gain control circuits; as the signal level increases, the changing resistance of the bulb can modify the feedback level in order to hold the level constant.
A resistor.
A shadoof is used to get water from one level to another. It is usually used to raise water from a lower level to a higher one.
A cement resistor is typically used as a power resistor (a resistor whose power rating is greater than 1 W).
the material we used is resistor because it did`t stop flowing.
Which type of resistor is commonly used in automotive circuits?
A typical resistor will burn out when it dissipates power in excess of double its power dissipation rating for an extended period of time. The power dissipated by a resistor is equal to I2R or E2/R, where E = the voltage across the resistor I = the current through the resistor R = the resistance of the resistor
Any dam will raise the water level behind it.
A Resistor Is Used To Limit The Current In A CircuitFurther AnswerA resistor is sometimes used to modify the natural resistance of a circuit -e.g. by adding a resistor in series, you can increase the natural resistance; by adding a resistor in parallel, you can decrease the natural resistance. Two or more resistors can be used to create a voltage divider -a method of obtaining a voltage lower than the supply voltage in a d.c. circuit.Use of resistor is to produce a particular amount of resistance to the flow of current
I want you to tell me the answer
A strong pullup means using small value resistor for pull up whereas a weak pullup means using high value resistor for pulling the signal to Vcc. A strong pullup reduces the RC time constant. Soumen C