answersLogoWhite

0

What else can I help you with?

Related Questions

If you have an internal Vent stack that does not go to the outside wall what vent cap would you use?

try studor PAPA system.


What could be wrong with my septic system. I had a new system installed 6wks ago. Now for the past month when the water is run I get a sewer gas smell in the house that will go away within 5 min?

It depends upon the venting that is used, look for your vent pipes on the roof and see if any are close to open windows. If you find a particularly close vent pipe (and you home has several vent pipes) you can add a "Studor Vent" to the top of the vent. A Studor vent is the equivalent to a one-way air valve that only allows air to pass, or be drawn, into the pipe, so that sewer gases will be greatly reduced. You don't even have to use pipe cement/adhesive to secure the Studor Vent.


What is Studor v Bohinju's population?

The population of Studor v Bohinju is 109.


What is the open pipe in the middle of the plumbing for your double sink with dw and disposal that sometimes backs up and spews all over under the sink and is it correct or required?

It could very well be an "Air admittance valve." Plumbing systems require a smooth flow of air and water to operate properly, these vents historically were routed through the roof and allow for the relief of positive and negative pressures in the vent system. "Air admittance valves" are installed under sinks and lavatories that are inconvienient to route a vent to the roof. These vents while handy do not respond well to back pressure, they are designed to seal during moments of positive pressure and "breathe" while in moments of negative pressure, this is to prevent sewer gas from entering the room. The purpose of the trap is to prevent sewer gas from entering the room, the purpose of the vent is to relieve positive and negative pressures in the drain and vent system to prevent trap seal loss. The slang name for an "air admittance valve" is studor vent. "Studor" is a manufacturer of AAV's Hope this helps


Why would you need a direct vent water heater?

When you cannot use B vent to find a way to vent the HWT through to the roof!


How to clean a roof dryer vent effectively?

To clean a roof dryer vent effectively, start by disconnecting the vent from the dryer. Then, use a vent cleaning brush or vacuum to remove lint and debris from the vent. Next, climb onto the roof and locate the vent opening. Use the brush or vacuum to clean out any remaining lint and debris. Finally, reattach the vent to the dryer and ensure it is securely in place.


How do you use the word vent in a sentence?

every house requires at least one Vent. Otherwise you will suffocate.


Use the verb 'vent' in a sentence?

I called my best friend to vent about my bad day at work. I can't solve your problem, but I can listen while you vent about it.


How do you use the vent on steamworks island?

To get a boost from a steam vent, walk to the middle of the steam vent and then jump up. If you jump onto the steam vent from the top, it won't boost you up as high.


How can I effectively clean the inside of my dryer vent?

To effectively clean the inside of your dryer vent, you can use a vacuum with a long attachment or a dryer vent cleaning kit. Disconnect the vent from the dryer and vacuum out any lint or debris. You can also use a dryer vent brush to scrub the inside of the vent and remove any remaining buildup. Regularly cleaning your dryer vent can help prevent fires and improve the efficiency of your dryer.


How do you bend vent pipes?

Use fittings.


What causes air conditioner in 2004 Ford Ranger to run even when control is in vent position and no ac is desired?

read your owners manual. i had to also. there is only two vent settings that will not use the compressor. the vent setting with the upper and lower vent showing will use the compressor.