0
What else can I help you with?
A relative bearing is always measure from?
North to East. So Southeast would be Bearing 135.
Why use journal bearing in turbine?
putting a journal bearing at each end of the turbine rotor or shaft would be to support it.
Can you install an engineered wood floor over a ceramic tile floor?
yes, but it will slide over the years so I would not
What does over capacity mean?
In a way it seems like a contradictory idea. How can a machine be producing 'over capacity' if capacity is the limit of its ability?When elevators are designed, engineered and built, all the technical data connected with the materials used, their ability to carry loads, and changes that occur to materials during use (related to heating up, for example) all go into a careful estimate of what the elevator can safely carry, and probably also an estimate of the absolute maximum load, which if exceeded, would cause failure. But these are theoretical, or mathematical estimates of the elevator's ability. Given any number of factors, a specific elevator may be able to carry a load larger than the calculated limit for some length of time. But weights just a little over normal safety capacity would cause more rapid wear of the system, and would probably not cause catastrohpic failure.
What type of bearing would be fitted to a fractional kW electric motor?
The type of bearing that would be fitted to a fractional kW electric motor will depend on the model and maker of the motor. Deep grove ball bearings are the most common bearings used.
What is the difference between nominal and design capacity of a plant?
Nominal capacity is the rate at which the parties involved would like for the plant to operate. Design capacity is the rate at which the designers have engineered the plan to operate.
How to improve the towing capacity for a 2004 Chevy Silverado Z71 5.3 liter engine?
I would like to know how to improve the towing capacity of my 2004 Chevy Silverado Z71. It has a 5.3 liter engine
Installation of engineered flooring?
The best locations for installing engineered flooring would be outdoors or in a garage. It is a fantastic flooring option.
Why does the foundation of a very large building often go all the way down to the bedrock?
Because large buildings weigh a lot. Subsoil has varying degrees of 'bearing capacity' - the amount of weight it can carry. If you put a lot of weight on a subsoil of low bearing capacity it will compact, or be pushed aside. If the subsoil on the site of a large building has insufficient bearing capacity to carry the loads imposed on it by the building then the foundations would have to be taken to bedrock as this has 'unlimited' bearing capacity.
Proper healthy lifestyle behaviors and sensible exercise would?
prevent disease, improve the quality of one's life and maximize physiological capacity.
How to calculate an excellent structural efficiency score?
To calculate an excellent structural efficiency score, you would typically assess the ratio of the structure's weight to its load-bearing capacity. A higher load-bearing capacity relative to the structure's weight indicates better efficiency. Factors such as material strength, design optimization, and construction techniques play crucial roles in determining the structural efficiency score.
Where do you normally use a reinforced wide strip concrete foundation?
A reinforced wide strip concrete foundation is used if the soil is soft or is of a low bearing capacity. This would not work for heavy or clumpy soil.
What would be possible benefit of increased FDI inflow in India?
it improve foreign capital in country,offer huge investment capacity there by increase the employment and living conditions
What would be done if a unitised bearing was faulty?
If a unitized bearing is found to be faulty, the first step would be to stop the machinery to prevent further damage. The bearing would then be inspected to determine the extent of the fault, followed by removal. Depending on the damage, the bearing may be repaired or replaced with a new unitized bearing. Finally, the system would be tested to ensure proper functionality before returning it to operation.
What is a fixed bearing?
a bearing is the direction one object is from another object.A bearing can be taken to a fixed or moving object, so a fixed bearing would be the direction towards a fixed object.
What automobile did Adolf Hitler have engineered with the idea that all the Germans would have one?
Volkswagon
A relative bearing is always measure from?
North to East. So Southeast would be Bearing 135.
