Only if the trap fell off and it was not properly vented
There are multiple reasons why your washing machine might not drain. The drain line could be clogged with debris or even clothing, the pump pulley could be frozen, or the pipe that the washer drains into could be clogged.
Either dried out P-trap or possibly no p-trap or break in drain line after p-trap
The most likely cause of a washing machine leak is a small hole in the rubber door seal which can be easily replaced.As a temporary measure the seal can be loosened and twisted 180degrees until the top is at the bottom. Probably a bad tub bearing. Live with it, or get a new machine. +++ It won't be the bearing because the shaft is outside of the drum, but it could be a leak on one of the pipe joints, or (as happened on mine) on the pump, which does use a shaft running through a bush and seal from the inside to the outside of the pump body.
The washing machine is pumping out water faster than the drain pipe can handle. A trap in the drain pipe to which the washing machine hose is attached is required and that makes the water flow slower than you might expect. Having the washing machine some distance from the main drain line requiring a long horizontal run in the machine's drain pipe will also result in a slower flow. Other causes could be: undersized waste pipe, backward wyes or santees, backgraded piping, backed up gray water system. An obstruction such as a checker piece or poker chip could be lodged within the pipe. Such an obstruction acts as a valve or flap that will pivot out of the way when a snake is pushed through the pipe but pivot closed when water attempts to flow through. Nowadays a two inch drain pipe is recommended. Some cities require two inches or larger. Do not seal around where the washing machine hose is hooked onto the drain pipe as this could overload components within the machine.
It could be that your hose is plugged andyou should try this first before calling it quits.
Vibration could cause it to jump as from a minor earthquake or washing machine.
There could be a variety of reasons why a persons daughter may sit on a washing machine. She may like the vibrations from the washing machine. She also may be waiting for the washing machine to end so that she can move the clothes to the dryer.
There are a few reasons why your washing machine is not filling up with hot water. A tube could be plugged. There may also be an issue with the hot water heater. Have a professional check the machine.
You should ask around your neighborhood, or call the company that you bought the washing machine from. It could still be under warranty and could get fixed for free.
There could be several reasons why a washing machine is not washing, such as a clogged filter, malfunctioning water inlet valve, broken drive belt, or an issue with the motor. It's best to check these components or consult a professional to identify and fix the problem.
Yes, a BB pellet could potentially damage a washing machine if it were to get inside the machine and interfere with its moving parts, such as the drum or pump. It is best to avoid introducing any foreign objects into the washing machine to prevent damage.
How long is a wash cycle? A normal wash cycle usually takes between 50 minutes to an hour to complete. However, this time could be faster or slower depending on load size and the cycles or options you choose.
Possible causes for a washing machine not ringing out water from clothes could include a clogged drain pump, a malfunctioning lid switch, or a problem with the machine's motor or belt. It could also be due to imbalanced loads, which can prevent the machine from spinning properly.
You may want to check your motor on the washing machine. It may have a bad short.
One can purchase a Electrolux washing machine at almost any home department stores. Best Buy has a great selection of washers and dryers that include Electrolux washing machines.
There are multiple reasons why your washing machine might not drain. The drain line could be clogged with debris or even clothing, the pump pulley could be frozen, or the pipe that the washer drains into could be clogged.
It could be that your transmission housing is leaking. You will probably find oil underneath the machine as well.