0
What else can I help you with?
What is Id versus od size in copper fittings?
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
How do you measure diameter of water hose?
Inside diameter just like copper tubing
What is the thickest copper pipe?
K copper.
How much pressure can copper take?
Are the joints brazed or soldered? What diameter is the tubing? When you say copper are you asking type K, L ,M , DWV , M or TP
What is the difference between type k and type L copper?
Type K has a thicker wall than type L. Type K is usually used underground and type L is used in Commercial buildings. Type M is usually used in Residential Buildings. M tubing is very thin and in decent codes it is not allowed except for possibly heating. L tubing is used for water supply ABOVE ground for both residential and commercial K tubing having the heaviest wall thickness of copper TUBING is used for under ground applications
How do you bend copper pipes?
Depends if the copper tubing is annealed or drawn type as not all copper tubing if bendable
Lever type tubing benders are best used for what copper?
tubing benders are the best used for
What is the best way to connect PEX tubing to copper piping using a PEX to copper adapter?
The best way to connect PEX tubing to copper piping using a PEX to copper adapter is to first cut the PEX tubing to the desired length and then slide the PEX fitting onto the tubing. Next, use a crimping tool to secure the fitting onto the tubing. Finally, solder the copper adapter onto the copper piping and connect the PEX fitting to the copper adapter.
Is copper tubing pure copper?
No is is only 99.999 % puure
What is used to support vertical copper tubing against wood blocking?
The popular and proper mounting technique for copper tubing is a copper tubing clamp for the appropriate size. This clamp is made of copper and should be mounted with copper nails. It resembles a piece of tubing of the appropriate size, a half inch wide with two ears on either side with holes for nailing.
Is copper tubing homo or hetero?
Copper tubing is an inanimate object and does not have a sexual orientation. It is made from copper metal and is commonly used in plumbing and heating systems.
What is the best tool for cutting copper tubing?
Copper tubing is best cut with a straight saw, ideally diamond tipped for the cleanest cut.
Is copper tubing a homogeneous or a heterogeneous?
Homogeneous
How can I connect PEX tubing to copper pipes?
To connect PEX tubing to copper pipes, you can use a fitting called a PEX-to-copper adapter. This adapter has a PEX side that can be crimped onto the PEX tubing and a copper side that can be soldered onto the copper pipe. This creates a secure and watertight connection between the two types of pipes.
How do you bend copper tubing?
that would depend on the temper of the tubing as some types cannot be bent
What is the meaning of ACR as applied to tubing?
ACR stands for "Annealed Copper Refrigeration" and refers to a specific type of tubing that is commonly used in refrigeration and air conditioning systems. ACR tubing is made of annealed copper, which is softer and more flexible than rigid copper tubing, making it easier to install and work with in these applications.
What are the best practices for bending quarter inch copper tubing without causing damage or kinks?
To bend quarter-inch copper tubing without causing damage or kinks, it is best to use a tubing bender tool specifically designed for copper tubing. Make sure to support the tubing properly and bend it gradually, avoiding sharp angles. Additionally, using a lubricant can help reduce friction and prevent kinks.
