Leakage current is an allowance for loss for leaking. It means that a partial loss, such as stocks, is planned for and expected.
the one you bye
Standard or automatic transmission??? In most vehicle situations the switch unscrews out of the likage side of the transmission.
First check the nut at the bottom of the wiper arm to seee if it's loose. If tight, fault is in wiper likage to wiper arm not working
the likage and cables probably need some lube a dragging clutch will make it grind when trying to put in gear also if the clutch is hydraulic operated, it may be low on hydraulic fluid due to a leak in the system.
Could be that the steering wheel rubber bushing is worn or lose. This bushing is located in the engine compartment, between the end of the steering wheel coulomb and the steering wheel likage...Tom
Remove the bottom of the rear seat. Notice a small metal cover over the top of the hump. Remove the cover to expose a joint for the shift likage. This joint can loosen up over time. Realign the joint and tighten securely.
Don think so, but check to see if any adjusting points on likage- Try pulling up on clutch pedal sometimes that is the adjustment I believe it is self adjusting with the hydraulic system. Check the fluid level in the resevior on driver side under hood next to fuse box.
I do not know when this questions was ask. In Ka steering noise .. show it immidiately to your dealer. I had similar problem with noise and hard seeting with funny noises. I end up with 2,000$ repair charges. Steering pump oli likage on battry charger and I need to replace all...
automatic, or standard 5 speedAnsweron a 5 speed AnswerWell.. i have a 98 sc2 5-speed and all i did was remove my center counsel. there are about 2 screws on both the pass. and div. side, about in center-rear. a plastic cover might conseal it. just use a flat tip or a pocket knife to open it. Just look carfuly and you shouldn't miss it. you might have as try in the rear of the counsel so you should just be able to take it out. lift from the back first and then the front of the counsel. The plastic part for the radio and the thermostat might clip on to it so you might have to take that out too. I know i didnt. There will be wires for going to your window controler and dim light so you should just be able to quick disconnect them. this should expose the likage for the shift knob. Move the leather cover for the Kobe out of the way so you have more space to work with. I replaced it the original with a shift knob that was 3'' shorter. but if you just want the actual knob itself then it should just come right off by pulling.you might have to turn it about 90 degress and then pull it but im not too sure about that..all i did was replace the knob with linkage (short sifter) you have to tear it off because the shifter has a c clamp inside the material part of the shift knob.