0
Slip Ring Induction Motor and Squirrel Cage Indution Motor
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the full form of DTS-SI?
digital twin spark swirl induction
What is the full form of pal?
PHASE ALTERNATING LINE
What is the full form of LT and HT motor?
LT motor abbrevation
What is the full meaning of PM?
in the clock,it means post meridiem
What is the meaning of the idiom take off full blast?
To "take off full blast" means to start quickly. The idiom refers to a motor or jet engine starting off at full blast or full throttle, which would be as fast as possible.
What should be the maximum difference between two phases in three phase induction motor at full load?
120 degrees
What is the solution for running three phase induction motor at voltage less than its rated voltage to drive full load?
The solution to this problem is to get the same size motor in HP at the correct voltage. This way the motor can correctly drive the connected full load without tripping the motor protection.
How do you calculate the no-load current of a three phase induction motor?
All transformers, single phase or three phase have a "no-load current" rating. That is simply the nameplate rating of the Xformer in VA, (volt-amps) or KVA (1000Volt-amps) for larger Xformers. Simply divide the nameplate rating in VA or KVA by the supply voltage and you'll get the Xformers potential maximum output in ampheres.
Why are no starting components needed on three-phase motors?
Yes, by using a DOL Starter, which gives a controlled "soft-start" for the motor even though it is always connected in delta configuration.In this type of starting a 3-phase motor, full voltage is applied to the motor through relays and contactors. Its is the most common type of 3-phase motor starter used.DOL means Direct On-Line starter.
How do you calculate breaker capacity of 10 hp three phase induction motor?
The first thing you have to do is find the full load amps of the motor. The wire size feeding the motor has to be 125% of the full load current. The breaker is usually 250% of the full load current. If the voltage and amperage had been added to the question the exact breaker size could have been calculated.
What are the advantages of three phase induction motors over the other motors?
A Single phase induction motor includes a main winding, an auxiliary winding, a run capacitor, & a subsidiary star device. The auxiliary winding is configured such that the number of turns of the aauxiliary winding through which a current flows, varies according to the operating mode of motor. When the motor starts, the number of turns of the auxiliary winding through which a current flows is reduced there by increasing the start efficiency of the motor. when the motor runs in normal mode, the number of turns of auxiliary winding through which a current flows is increasing there by increasing the operations efficiency of motor
Is it correct to use the Fast fuses for one three phases Induction motor start up?
No, if anything motors need time delay fuses in the start up phase of their rotation. The motor will draw up to 300% of their full load amperage. Time delay fuses get the start up current past this phase of start up.
Just at start the slip of a 3-phase induction motor is?
Just at start slip is 100% because the rotor is not moving yet but the stator field is in full rotation.
A particular 3 phase induction motor has a LRA of 100 amps What is its approximate starting current?
LRA (locked rotor amperage) is not considered. Starting current for a motor is usually in the neighbourhood of 300% of the FLA (full load amps). The FLA is taken from the motor's nameplate.
What is the star delta working principle?
when starting a 3 phase induction motor,first start with star connection,because reduced current is being applied and after start change it to delta connection then. full line current is applied to the motor.
What is the standard method of starting for a large 3 phase induction motor?
Standard method would be called " across the line" simple motor starter contactor with overload protection. Connected directly to incoming power, cotactor closes and full voltage is put to motor windings.
Waveform of three phase full wave converter?
lecture of three phase full wave converter
