answersLogoWhite

0

Connector is a small electrical part which allows electricity to go from one wire to another. A electric cord plug is also a connector. Coupling is normally referred to transference of power, or tranference of electric waves, from one device to another, from one mechanical part to another and so on.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is difference between fluid coupling and flexible coupling?

i don't know actually


What is the difference between rigid and flexible couplings?

What is the difference between rigid and flexible coupling.


Difference between SC and LC connector?

One difference between an SC and an LC connector is that an LC connecter is smaller in size than an SC connector. Also, an LC connector is considered a latch connector, whereas an SC connector is considered to be a push-pull connector.


What is the difference between a socket and a coupling?

A socket is a female fitting that connects to a pipe or tubing, while a coupling is a device that connects two pipes or tubes together. Couplings can be either rigid or flexible, while sockets are typically fixed and do not allow movement.


How do you calculate the coupling constant of doublet of doublet?

You will have two coupling constants, Ja and Jb.  Ja is the frequency difference between the CENTERS of the TWO DOUBLETS.  Jb is the frequency difference between the TWO PEAKS in a SINGLE DOUBLET.


What is difference between splices and connector?

A demountable joint between fibres is known as connector. A permanent bond between fibres are called as splicers.


How do you connect the slave cylinder coupling?

If the slave cylinder does not have a flared nut coupling, then it should have a snap connector. The line end plugs into the cylinder and the coupling snaps to hold it into place.


Difference between coupling and pipe union?

A coupling is a threaded or soldered solid fitting, a union is a fitting that joins two pipes and can be taken apart with wrenches.


What is the difference between a half coupling and a full coupling?

half coupling used to take branch from header ie: 2" header to 3/4' branch. where full coupling used to connect to straight pipe. ie: 2" to 2" pipe connection.


What is the difference between clucth and coupling?

A clutch is a mechanical device that engages and disengages power transmission between two shafts, typically in a manual transmission system. A coupling is a device used to connect two shafts together at their ends to transmit power. While clutches are used for intermittent operation, couplings are used for continuous power transmission.


What is the difference between transformer coupling and RC coupling?

RC COUPLING :- is the most Commonly used Coupling Between the two stages of a cascaded or multistage amplifier because it is cheaper in cost and Very compact circuit and provides excellent frequency response. TRANSFORMER COUPLING :- Impedence Coupling results in more efficient amplification because no signal power is wasted in Inductor L. Such Coupling has the drawback of being larger, Heavier and Costlier than the RC COUPLING. Impedence Coupling is rarely used beyond audio range . by : Muhammad zubair.... muet student of telecom.


What is the difference between an ordinary transformer and resonant coupling energy transfer?

An ordinary transformer uses mutual inductance to transfer energy from one circuit to another, while resonant coupling energy transfer utilizes resonance between the coils to enable more efficient energy transfer. Resonant coupling allows for wireless power transfer over larger distances compared to traditional transformers.