answersLogoWhite

0

It's on the driver side close to the firewall. The fluid type is indicated on the top which is about 2 1/2 to 3 inches in diameter.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the clutch fluid reservoir for 1988 325i?

The clutch fluid is located in the same reservoir as the brake fluid. As a dot 4 brake fluid, used for the breaks and the clutch.


Where is the clutch reservoir on a 1992 BMW 325i?

nxt to the brake reservior


What is 2006 BMW 325i brake fluid?

The 2006 BMW 325i uses DOT 4 brake fluid, which is a hydraulic fluid designed to provide the necessary pressure for the braking system. It's important to use the recommended fluid type to ensure optimal performance and safety, as different brake fluids have varying boiling points and properties. Regular maintenance includes checking and replacing the brake fluid to prevent moisture contamination and maintain braking efficiency. Always refer to the owner's manual for specific requirements regarding brake fluid for your vehicle.


Where do you put power steering fluid in a 1992 BMW 325i?

The power steering fluid goes below the intake manifold in a 1992 BMW 325i. This is where the power steering reservoir is located.


Where to you put the manual transmission fluid on a 1988 BMW 325I and what kind do I use I heard brake fluid and clutch brake fluid. I am confused.?

I had the same question. The transmission fluid actually goes in the power steering reservoir. Kind of strange, but true. For the type of fluid you want to use, check your bell housing. There should be a sticker on it that says what to use.


Can you jump a 325i BMW?

I have a 2006 325i and i have jumped it.


How do you replace rear brake pipe to BMW 325ci?

how do you put disc brake bmw90 325i


How do you reset disc brake warning light on 2004 325i?

To reset the disc brake warning light on a 2004 BMW 325i, you typically need to use a diagnostic tool or follow a manual reset procedure. If you have a diagnostic scanner, connect it to the OBD-II port and clear the fault codes. Alternatively, you can turn the ignition to the "on" position without starting the engine, then press the brake pedal three times. If the light persists, ensure that the brake pads are properly installed and that the brake fluid level is adequate.


How much horsepower does a 2006 BMW 325i have?

215


Can you fit a v12 engine in a 2006 BMW 325i?

No


How much is a battery for a 2006 325I BMW?

$2000


What kind of power steering fluid for a 1995 BMW 325i?

dexron3