One or more cylinders on one side is/are not firing. Check by pulling a plug wire while the engine is running. If there is no change when you pull the plug wire than that cylinder is not doing anything. Replace the plug wire and pull another until you find the one that, when pulled does not affect the engine.
your problem is yu have a broken motor mount that will make the car shake when you start it and step on it
It is the accelerator pedal.
The accelerator pedal is to the right of the brake.
Accelerator cable? No. Accelerator pedal set up? Yes.Looks like 2 bolts to remove the pedal clusterfrom the floorpan and then there is a bolt going through the pivot for the gas pedal.
It is called the accelerator pedal, aka the gas pedal.
The accelerator pedal has the sensor incorperated. It is replaced as a unit. Part # 30683516
The accelerator pedal. Also known as a gas pedal.
to the right of the brake
it could be a broken link betwen the pedal and the carberetta
Yes, they have a brake and accelerator pedal but no clutch pedal
The accelerator pedal position sensor in a 2005 Honda CR-V is typically located on the accelerator pedal assembly itself. It is mounted directly to the pedal mechanism, which is situated on the driver's side of the vehicle, near the floor. To access it, you may need to remove the lower dashboard panel or cover to reach the pedal assembly.
Gas pedal