0
What else can I help you with?
Where is the throttle position sensor located on a 2004 Pontiac Grand Prix?
It is on the accelerator pedal. You have to replace the whole pedal assembly
Where is the location of accelerator pedal sensor of crv 2005?
The accelerator pedal position sensor in a 2005 Honda CR-V is typically located on the accelerator pedal assembly itself. It is mounted directly to the pedal mechanism, which is situated on the driver's side of the vehicle, near the floor. To access it, you may need to remove the lower dashboard panel or cover to reach the pedal assembly.
Where is the TPS SENSOR on a 2006 ford F350 6.0?
It's apart of the accelerator pedal. If you suspect it's bad replace the pedal assembly as a whole.
How to change a 1969 vw beetle clutch cable?
Step one is to remove the large wing nut on the clutch actuating arm on the transaxle, located ahead of the engine, oin the drivers side, on top of the transaxle. Next, you have to remove the accelerator cable from either the pedal assembly, or detatch it from your carb linkage. Lastly, you need to remove the two bolts holding the pedal assembly on, one in front of the accelerator pedal, and one behind it. The pedal assembly should pull right out of it's mounting hole and you will have access to the clutch pedal hook and the clutch cable. Remove the clutch cable, inspect the clutch pedal hook to make sure it isn't getting too worn out ( I have had one of these hooks break off on me from years of driving and a Kennedy pressure plate ), then thread the new clutch cable into it's guide tube, hook the end onto the back side of the clutch pedal, re-install the pedal assembly, then the large wing nut and accelerator cable. B. Nash
How do you change the accelerator pedal position sensor on a 2003 Chevy trailblazer?
This project is fairly simple. there are a few bolts and a electrical connector that hold the accelerator pedal in place. the accelerator and sensor are all inclusive. look under the drivers side at the pedal find the bolts and electrical connect remove and replace. it's very simple no real technical expertise required.
How do you replace throttle cable on 1989 ford bronco?
To replace the throttle cable on a 1989 Ford Bronco, first disconnect the negative battery cable for safety. Remove the old throttle cable by detaching it from the throttle body and the accelerator pedal assembly. Install the new throttle cable by connecting it to the throttle body and fastening it to the accelerator pedal. Finally, adjust the cable for proper tension and reattach the battery cable before testing the throttle operation.
How do you attach the accelerator pedal assembly to the carburetor in a 1966 Chevy C10 pickup with a 350 engine?
with rivets
How do you change the throttle position sensor on a 2005 mustang gt?
The APP sensor is located on the right side of the upper end of the accelerator pedal * Disconnect the negative battery cable * Remove the knee bolster * Disconnect the electrical connector from the APP sensor * Remove the APP sensor and pedal assembly mounting nuts and detach the assembly from the firewall
What pedal makes a car go faster?
It is the accelerator pedal.
How do you fix a sticking accelerator pedal in 2001 Mercury Villager?
the butterfly tends to get gunked up. remove air intake assembly to get to throttle body butterfly. i used an old toothbrush and some carb cleaner on it to remove buildup.
Remove clutch pedal 2004 GMC sierra?
how to remove a clutch pedal assembly 2004 gmc sierra
How do you replace accelerator pedal sensor 2000 Isuzu trooper?
Remove two 10mm bolts supporting the pedal. Disconnect the electronic unit connected to the pedal using a small flat head screwdriver. Take off two phillps screws attached to the unit.
