0
cable is probably frayed or snapped, same thing happened with 1997 528i. DO NOT try to fix on your own, lots of electrical problems follow. order parts online and take them to a body shop. parts cost no more than $40 including shipping for mine. try www.bmrparts.com or (800)269-0863. good luck.
Spoke to BMW engineer who said a good pull on release lever at same time as helper pushes down over headlamps may free a stiff bonnet or hood catch was successful
What else can I help you with?
Where is the water pump located on a 94 Isuzu rodeo?
The pump is basically directly behind the fan on the engine You need to remove the fan and bracket The front engine cover and the timing belt to remove the pump It is driven by the pump
What are the release dates for The Weather Channel Weekend View - 2006 How to Remove Ice from Your Car Windshield?
The Weather Channel Weekend View - 2006 How to Remove Ice from Your Car Windshield was released on: USA: 5 January 2014
Ignition module location on 1990 Buick Century?
You will find the ICM directly below the coils. Just remove the coils and you will be able to remove it. This is on a 1990 Buick Century V6 3300 engine. If you have a different engine I cannot confirm the location.
Where is the crankshaft sensor located in a 2001 olds?
It is located directly above the starter. Remove the starter and you will see it going into the side of the engine block.
How do you use carb cleaner?
Remove the air filter, and while the engine is running spray the cleaner into the carb directly, being careful not to stall.
How do you remove the crankshaft in a dodge stratus 2.7 L?
Remove the engine, place on an engine stand. Remove heads, oil pan, pistons, main caps and remove the crank.Remove the engine, place on an engine stand. Remove heads, oil pan, pistons, main caps and remove the crank.
Where is the camshaft sensor on c5?
The Camshaft Position Sensor (CMP) is located at the rear of the engine, in the top center of the block. You have to remove the intake manifold to access it .... it is directly behind the knock sensors at the back of the engine.
Where is oil filter on a 2002 Mazda mx5?
Directly under the intake manifold on the passenger side of the engine. If you have thin arms, it is possible to reach it from above the engine. Otherwise, if you remove the passenger side tire, you will find it there.
Where is the 1988 Honda goldwing engine oil drain plug located?
The oil drain plug is located on the underside of the engine directly below the filler hole. The head of the bolt will need a 17mm socket to remove.
Where is the oil filter in a1995 Mazda miata?
Directly under the intake manifold on the passenger side of the engine. If you have thin arms, it is possible to reach it from above the engine. Otherwise, if you remove the passenger side tire, you will find it there.
Where is the oil pressure sending unit located on an 2001 Mitsubishi Eclipse 2.4l engine block?
back of engine right below intake manifold, lay under car, look directly up (center) on the back of the motor, there is 1 wire running to that, remove that wire, unscrew the lead (phillips) and use a 1" socket to remove the sensor back of engine right below intake manifold, lay under car, look directly up (center) on the back of the motor, there is 1 wire running to that, remove that wire, unscrew the lead (phillips) and use a 1" socket to remove the sensor
How do you release fuel line pressure for a 1987 S10 pu?
While engine is running remove the fuel pump fuse. Engine will run out of fuel when pressure drops.
