No,it will mess up your computer.
Lock doors with electric.
To reset the alarm on a 1999 Plymouth Grand Voyager SE, first, ensure the vehicle is in the "Off" position. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Wait a few seconds, then turn it back to "Off." If the alarm continues to sound, disconnect the battery for a few minutes and reconnect it to reset the system.
you can only use diagnostic equipment to turn the alarm off or see whats wrong with it and garages rip you off on the prices they charge ezza1969
The factory alarm is part of the body computer programming and can not be removed.
Pull the fuse.
You can't, it is part of the body computer and can't be removed.
The alarm is located on the braking system on the Chrysler Voyager 12-2004 European model.
To turn off the horn alarm on a 1999 Plymouth Grand Voyager, locate the alarm control module, which is typically found under the dashboard or near the fuse box. You can disconnect the battery for a few minutes to reset the system. Alternatively, check the owner's manual for specific instructions on disabling the alarm. If the problem persists, consider consulting a professional mechanic for assistance.
The factory alarm is built into the Body Computer. It is not possible to unhook it.
Remove the fuse.
i had the same problem i just cut one of the wires leading to the switch that was causing the problem
you don't remove alarm system you cover it with plastic and go back with paint brush and do finishing touches...