If the convertible top on your 1991 Porsche is not going down, it could be due to a few common issues. Check the fuse related to the convertible top mechanism, as a blown fuse can prevent it from operating. Additionally, inspect the hydraulic fluid levels if your model uses a hydraulic system, as low fluid can cause the top to malfunction. Lastly, there may be a mechanical issue or a problem with the switch, which would require further diagnosis.
PUT EMERGENCY BRAKE ON
the Porsche 944 1991 has 247MPH
Ford F150 97 - 04porsches*Porsche 944 82-91
I found the answer is only the 2
The fuel pump on a 91 ford ranger is an electric fuel pump and is located in the gas tank. you must remove the gas tank and then you will see it there on top where it sits down in the tank.
Yes, that should work just fine
The 1988 Porsche 944 is designed to run on premium unleaded gasoline with an octane rating of 91 or higher. Using a lower octane fuel can lead to engine knocking and reduced performance.
(91/100) x 200 = Cancel down by '100' Hence (91/1) X 2 = 91 x 2 = 182 The answer!!!!!
Cheers.
the fuse panel on the driver side, there is a fuse in the top left coner for that its a 10 amp check that, if its not that then it could be the headlight button
you would haft to disconect the top cylinder
Yes. The tops from 80-96 will interchange. The only difference is that beginning in 92, the rear seat shoulder harness bolted to the top..plus they had the the third brake light included. I've been told that the tops from 78-79 Broncos had a different radius at the upper front corners and thus won't interchange with those from 80 on...but you should be good with the 95 on the 89. ==== There is a slight difference between tops from an 80 - 91 and a 91 - 96 Bronco. The alignment pins on an 80 - 91 were in the body, and stuck up into an alignment slot in the top. On the 92 - 96, the alignment pins were in the top, and stuck down into an alignment slot in the body. If you put an 80 - 91 top on a 92+, there won't be any issues. But if you put a 92-96 top on an 80-91, the alignment pin will get in the way. Nothing serious, but it is still an issue. The alignment pin can be removed.