NO. Oil sump drain plugs only need to be fairly taught. Just barley tight so they don't come out. You run the risk of stripping thread if you tighten them to much. If you really need a poundage for it, for about 10f-lb. Not much
You need aTorx 45 size
Yes you need a Torx bit to remove the sump plug. Also be careful when you remove the sump plug, there is a O ring on the plug that may fall off. Oh by the way, alot of Astra bolts use Torx (Many manufacturers recomend that you replace the sump plug & o ring)
On 1998 year ,The sump plug is on the bottom of sump at the rear right.
The oil sump drain plug on a 2007 Holden Astra is typically located at the bottom of the oil pan, which is situated beneath the engine. To access it, you may need to raise the vehicle, as it is usually positioned towards the rear of the oil pan. Be sure to have a suitable container ready to catch the oil when you remove the drain plug. Always consult the vehicle's service manual for specific details related to your model.
T45
Vise grips with curve jaws
5.5 mm Allen Key
What size sump plug do you need for a 2002 reg clio
do you need to take the engine out to change the sump on a vt can it be done without taken the engine out
The oil filter on a Holden Captiva Diesel can be located under the alternator. It is next to the engine oil sump plug and at the back of the car's engine.
The oil sump plug for an Opel Astra typically requires a 13mm socket or wrench to remove. However, it's always best to check your specific model's manual, as sizes may vary slightly between different engine variants and model years. Ensure to use the correct size to avoid stripping the plug.
The rubber bung on the sump of an Astra 1.6 16V is a plug used to seal the oil drain hole, allowing for oil changes without removing the entire sump. It prevents oil leaks and contamination while ensuring that the engine maintains proper oil levels. This component is crucial for maintaining engine performance and longevity.