No. Often an electrical component will fail when it gets hot. It can be a little difficult to find if you aren't accustomed to diagnosing engine problems.
The 2.8 engine doesn't use a cam sensor.
I don't know of a kill switch but there is a crank sensor.
On the engine.
it does not have a high pressure switch all it has is a evaporator temp sensor/switch.
The O2 sensor on a 1988 F250 is not near the engine. Go to the exhaust manifold and down the length. It is near the catalytic converter.
in the distributor in the rear of the engine. sometimes known as a hall sensor
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine
Yes and its right behind the tbi
The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.
It should be on the side of the engine block over by the starter.
If it has a computer it is the knock sensor.