The small grill around the fog light pulls out. Start with the drivers side, there is a small clip inside the grill on the left side. Use a small flat head screw driver to pry it towards the fog light (doesn't take much pressure). Then pull the grill out. This will expose two Phillips head screws above the fog light housing. Remove these and take the whole assembly out. Passenger side is similar.
Try Shokan Coachworks in NY (Currently out of stock) or ebay?
How do you replace a 2004 Audi a6 quattro 2.7t starter?
where is the starter located on the Audi a6 quattro
h1 bulb look in the fog light section of the store
yes 96 through i believe its 2001 only have one rear fog light but the harnes has the space for the bulb on the other side but there is just no opening in the back of the light
audi a 6 1998
with your hands ?
To replace the tail light on a 2005 Audi A6, first open the trunk and locate the access panel behind the tail light assembly. Remove the screws or bolts securing the tail light, then gently pull the assembly out. Disconnect the electrical connector and replace the bulb as needed before reinstalling the assembly and securing it with screws. Finally, test the new tail light to ensure it functions correctly.
where do you put the tranmission fluid on a 1999 Audi A8
My 99 Audi Quatro 4.2 A6 Avant has a recurring appearance of the ABS light & Brake Warning light. Any Suggestions?
You will need to take the 2006 Audi A6 to a mechanic to have the service light properly reset. In some cases, a person can undo the battery to reset the light.
To adjust the fog lights on a 1998 Audi A6, first ensure the vehicle is parked on a level surface and the headlights are properly aligned. Locate the fog light adjustment screws, usually found on the back of the fog light housing. Use a screwdriver to turn the screws, adjusting the fog lights horizontally or vertically until they are aimed just below the horizon and towards the sides of the vehicle. Always check the alignment by turning on the fog lights and observing their beam pattern.