How do you remove a radio from a 190E?
To remove the radio from a Mercedes 190E, first disconnect the car battery to ensure safety. Use a flathead screwdriver or a radio removal tool to carefully pry off the trim surrounding the radio. Next, unscrew the mounting screws holding the radio in place, then gently pull the radio out. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
To remove a Mercedes 190E radio, first, ensure the car is off and disconnect the negative battery terminal to prevent any electrical issues. Use a set of radio removal keys or flat tools to pry the radio out gently from the dashboard. Insert the keys into the slots on the sides of the radio and pull them outward while simultaneously pulling the radio out. Once it’s loosened, disconnect the wiring harness at the back to fully remove the unit.
by the oil filter
call the dealership give the vin #,and they will give you the radio code
In a 190E Mercedes, the radio fuse is typically located in the fuse box, which is usually found under the dashboard on the driver's side. You may need to remove a cover to access the fuses. Look for the specific fuse labeled for the radio or audio system in the fuse diagram, which is often found on the inside of the fuse box cover. If you're having trouble locating it, consult the owner's manual for detailed information.
I just bought a used 190E and had this radio problem at least 3 times in the past week. Just turn the radio on and use the station buttons and put in the code. Radio will come on at once. Ken Jones
Dextron/Mercon 3
enter code 11122, that should work. I needed the radio code for my 1992 Mecedes 190E, after the battery had been disconnected, so I called the dealer, who gave me the 4 digit code over the phone, no charge. I called and the code they gave me was shorter for a 190e it is 1133
how remove cylinder head
Remove the decorative radio cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness from the back of the radio.
On my 1984 190E, it is simple - there are a couple of tabs at the bottom of the back seat (where your heels would be if you were sittng), you have to look, the seat will pull right out!
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.