wher is fuel pump located on diesel vauxhall veectra
take to a garage to bleed needs a mehanical tool to prime bleed the fuel, if u try to self bleed it by turning the engine over u will destroy the fuel pump, and big money to replace it
on/ in the fuel pump. it should be the 1 with a single wire leading too it.
To bleed a diesel pump on a Vauxhall Astra, first ensure the fuel tank has sufficient diesel. Locate the bleed screw on the fuel pump, usually near the fuel filter. Using a wrench, loosen the bleed screw slightly and turn the ignition key to the "on" position without starting the engine, allowing the fuel to flow and air to escape. Once you see a steady stream of fuel without bubbles, tighten the bleed screw and attempt to start the engine.
it depends on if it is a common rail or not but they are quite easy to do if you have the locking kits for the cam shafts or not
ITS ON TOP OF THE PUMP.
open bleed valve on top of distribution pump, crank engine till fuel squirts from valve, tighten valve, turn over couple times. Add heat and fire up.
In a Vauxhall Vectra 2.0-liter diesel, the fuel pump is typically located in the fuel tank. Accessing it usually requires removing the rear seats and the fuel tank cover or, in some cases, lowering the tank itself. The pump is part of the sender unit and can be identified by its electrical connectors and fuel lines. Always consult the vehicle's service manual for specific instructions and safety precautions before attempting any repairs.
To change the ABS pump on a 1998 Vauxhall Vectra 1.8 hatchback, first, disconnect the car battery to ensure safety. Remove the plastic cover and locate the ABS pump, which is typically mounted near the brake master cylinder. Disconnect the electrical connectors and brake lines from the pump, then unbolt it from its mount and replace it with the new unit. Reattach everything in reverse order, ensuring that you properly bleed the brake system afterward to remove any air.
On the cylinder head (gearbox end), under the vacuum pump.
take of top of inj pump cut 4 wires undo two screws on end of ribbon that hold sensor then un solder ribbon from ecu. i dont think this part is sold separate from pump.
lower radiator hose