Pretty much the same as you would any other car.
To bleed the cooling system on a 1998 Fiat Bravo 1.4 12V, first ensure the engine is cool and remove the radiator cap. Start the engine and let it reach operating temperature, allowing the thermostat to open. Then, with the heater set to maximum, open the bleed valve (if equipped) or the highest point in the cooling system to release trapped air until coolant flows without bubbles. Finally, top off the coolant level and replace the cap.
If the timing belt brakes on a bravo the engine will be whacked/busted as the Mk1 1.2 Fiat Punto is the only non interferance/ Free wheeling engine Fiat made be warned if in doubt change it out.
yes
the bonnet lever on a fiat brava is by the clutch pedel and has a red handle this may be the same on the bravo
There is no point in doing that as the Fiat Bravo HGT has a Normally Aspirated engine ( no turbo)
fiat bravo
its located at the rear of the engine to the right if you look you will see two pipes coming out of the bulkhead about 40mm wide its located on the top one
You can purchase a used Fiat Bravo from the Auto Trader website. Alternatively, you can purchase this vehicle from auction websites such as eBay and classifieds such as Craigslist.
how do u reset service light on 2007 plate bravo
The 1998 Fiat Bravo is equipped with a range of engine options, typically featuring 4-cylinder configurations. Most commonly, it includes a 1.4-liter, 1.6-liter, or a 1.8-liter 4-cylinder engine. Some variants may also have a 2.0-liter 5-cylinder engine, but the standard models primarily utilize 4-cylinder engines.
10mm
front are 16cm