answersLogoWhite

0

To change the gear shift knob on a 1999 Porsche Boxster, first, ensure the car is in neutral and the ignition is off. Remove the plastic trim surrounding the gear shift by gently prying it up, being careful not to damage it. Next, unscrew the old gear shift knob by turning it counterclockwise; it may require some force. Finally, screw the new knob in place by turning it clockwise and reattach the trim.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

How many oxygen sensors are in a 1999 Porsche boxster?

Four


How do you replace the headlight bulb on a 1999 Porsche boxster?

To replace the headlight bulb on a 1999 Porsche Boxster you will need to open the trunk and take out the screw of the spare tire compartment. Slide the entire headlight assembly out after loosening it with a hex socket wrench. Then, put a new bulb in place.


What is the number of the Porsche in Gone in 60 Seconds?

There are several Porsches in the remake of Gone In 60 Seconds: 1988 Porsche 959, 1999 Porsche 996, 2000 Porsche Boxster, 1961 Porsche Speedster. In the original film the Porsche stolen from an auto dealership is a Porsche 911.


How do you open trunk for 1999 Porsche boxster if trunk release cable is broke and key is in trunk?

dealers can do it - they have a way to get in from the engine compartment but won't share how it is done :(


Where is the 1999 Porsche boxster airbag fuse?

The airbag fuse for a 1999 Porsche Boxster is located in the fuse box, which is found in the front luggage compartment. Specifically, you can find it in the left side of the fuse panel. Look for a fuse labeled for the airbag system; it typically has a specific amperage indicated on the cover of the fuse box. Always consult the owner's manual for precise details on fuse location and specifications.


What is torque for oil filter on 1999 Porsche boxster?

The recommended torque for the oil filter on a 1999 Porsche Boxster is typically around 25 Nm (18.5 lb-ft). It's important to ensure that the oil filter is tightened securely but not overly tight, as this can lead to damage or difficulty during future removal. Always refer to the owner's manual or a service manual for the most accurate specifications.


Where is the fuse box on the 1999 Porsche boxster?

Plastic "door" at driver's left leg. Booklet containing readout should be located as insert on back side of this door.


How does the brake wear light on the dash 1999 Porsche Boxster get reset?

To reset the brake wear light on a 1999 Porsche Boxster, first ensure that the brake pads have been replaced and the wear sensors are properly connected. Then, turn the ignition key to the "On" position without starting the engine. Press the brake pedal several times to allow the system to recognize the new sensors. Finally, turn off the ignition and start the engine to confirm that the brake wear light has been reset.


How much oil does a 1999 Porsche boxter hold?

A 1999 Porsche Boxster typically holds about 9.5 quarts (approximately 9 liters) of engine oil when including the oil filter. It's important to use the appropriate type of oil, usually 5W-40 synthetic, to ensure optimal performance. Always check the owner’s manual for specific recommendations and guidelines regarding oil changes and maintenance.


How many 1999 Porsches 996 had been build?

In 1999, Porsche produced approximately 20,000 units of the 996 generation of the 911. This model marked a significant shift for Porsche, as it was the first to feature a water-cooled engine. The 996 was in production from 1997 to 2005, with a total of around 175,000 units built across all its variants during that time.


Porshe boxster 1999 check engine code p112?

The P112 code in a 1999 Porsche Boxster typically indicates an issue with the throttle position sensor (TPS), which can affect engine performance and fuel efficiency. It's advisable to check the TPS for proper function, as well as inspect the wiring and connections for any damage or corrosion. If the sensor or its components are faulty, replacing them should resolve the code and restore normal operation. Always consult a professional mechanic for a thorough diagnosis and repair.


How do you change a shift solenoid on 1999 cavalier?

only one of my window wipers are working what should i do?