0
I have a 2005 Fiat Panda Climbing, and just replaced the bulb on the heater controls. First you pull off the control knobs - just grip the handle and pull hard, some come off easy, some are more difficult. If you're not lucky, the handle will pull off but leave the bottom part still attached - it just snaps in with two tabs. In this case position the tabs in the holes and snap it back it, and next time pull straight up and don't pull sideways on the handle.
Once the knobs are off, you now have to get the plastic bezels off that the knobs go down into. You do this by using a sharp knife or screwdriver to pry the edge of the bezel up from the grey plastic of the dashboard. Once you get it up a little ways, use a wide screwdriver or knife to continue lifting it -- being careful not to cut or scratch the plastic. When you get it up high enough, you just grab it on both sides with your fingers and it will snap out.
When the bezel is off, you should be able to see the bulb (very small, only about 3 or 4 mm wide) which is pushed into it's holder. Now the trick is to get it out without breaking the glass. What I did was to use some double sided adhesive tape to cover the tips of needle nose pliers, then gently squeeze the bulb with the pliers and when the tape is firmly stuck to the bulb, pull it out. NOTE: look closely at the orientation of the bulb contacts when you pull the bulb out, so you know how to push the new one in!
Now you can take the bulb to an automotive shop, get a replacement (get 2 of them while you're at it, so you'll have a spare), push it in the holder - test it by turning the ignition key on and turning the lights on - and if all is OK, snap the bezel back in by lining up the tabs that hold it with the holes, put the knobs back in by matching the flat side of the shaft with the flat side of the hole in the knob, and you're done! (if the light doesn't work, try the other spare to make sure you didn't get a bad one - if both fail, you might have a wiring problem and will need a mechanic to look at it).
Congratulate yourself for saving a lot of euro the dealer would have charged you :)
What else can I help you with?
How do you change the right headlight bulb on a fiat panda?
To change the right headlight bulb on a Fiat Panda, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the bulb by gently pulling it off. Remove the bulb by twisting it counterclockwise, then replace it with a new bulb, ensuring it is securely in place. Finally, reconnect the electrical connector and test the new bulb before closing the hood.
How do you change the back headlight?
To change one's back headlight, one must first uncover the light bulb. Then one must unscrew the bulb. One must have another bulb to change the headlight. Screw in the new bulb.
How do you change a back- up bulb on an impala?
thru the trunk
How do you change the headlight bulb in your 2002 Trooper?
from the back you must remove about 4 nuts the i beleave you have to change the hole light not just the bulb
Head light bulb in a Fiat panda?
To replace the headlight bulb in a Fiat Panda, first, ensure the vehicle is turned off and the keys are removed. Access the headlight assembly by opening the hood and locating the back cover of the headlight unit. Remove the cover, disconnect the old bulb from its socket, and replace it with a new bulb, ensuring it is securely in place. Finally, reattach the cover and test the new bulb to confirm it works properly.
How do you change an indicator bulb on a 1996 Astra 1.4?
open the bonnet, locate the back of the bulb holder and rotate half a turn, pull the complete holder out to expose the bulb. change the bulb and reverse the process.
How do you change the 3rd stop light bulb in a 2000 Nissan Sentra?
To change the third light bulb, just grab onto the case inside the back seat of your car and pull it up and back. The case will pop out and expose the wiring and bulb
How do you change headlight bulb pajero shogun?
To change the headlight bulb on a Pajero Shogun, open the engine compartment hood. Locate the back of the headlight and twist the bulb off. Replace with new.
How does a tulip change for the winter?
It dies back into its bulb and lies dormant.
How do you change a rear bulb on a vw transporter?
Get out and walk to the back of the car
How do you change a light bulb?
To change a light bulb, first make sure the power is off. Unscrew the old bulb by turning it counterclockwise. Then, screw in the new bulb by turning it clockwise until it is secure. Turn the power back on to test the new bulb.
How do you change a front side light bulb on a Hyundai 2001?
uncase, unscrew old bulb, screw in new bulb, put case back on
