answersLogoWhite

0

To change the speed control on a 1996 Audi A4 Quattro, first, disconnect the battery to ensure safety. Remove the steering column covers to access the speed control switch, which is typically located on the steering column. Disconnect the wiring harness from the old switch, then install the new speed control switch by connecting the harness and securing it in place. Finally, reassemble the steering column covers and reconnect the battery.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where is the speed sensor control on 1996 Chevy lumina 3.1?

how u take off a transmission speed control sensor on a 1996 chev lumina


1996 a4 quattro 2.8 where is oxygen sensor?

the answer is ricky bobby


How do you change the ignition control module on 1996 mercury cougar xr7?

there is no ignition control module on the 1996 model its all through the PCM


How do you change a turbine speed sensor in a 1996 Oldsmobile Aurora?

Where is the speed sensor located on a 1997 Oldsmobile Aurora


How do you change the idle speed on a 1996 Chevy silverado z71 5.7L?

You CAN"T, It is not ajustable. You need to check the idle speed control valve. Also check for a vacuum leak on the engine. If you don't find your problem here, then ask your question again.


Your 1996 Chevy S-10 misses at idle speed?

i would change the spark plug wires


How do you adjust the idle on a 1996 Jeep Grand Cherokee?

Idle speed is not adjustable. The computer controls the speed with the idle air control motor on the back of the throttle body.


How do you install a heater core for a 1996 Audi a4 quattro?

Please look below in the related links section for a detailed how-to.


How do you get a 1996 Audi A6 radio off safe mode?

I have an 1996 Audi Quattro A6 i changed my batteri and my radio went to safe mode. How do i get my radio off safe mode?


Where is the speedometer cable on a 1996 ford explorer?

1996 and newer have an electronic speedometer and a vehicle speed sensor that operates your electronic speedometer and also sends a signal to the powertrain control module (PCM) The PCM uses this signal to control several different functions of the engine and transmission.. Your 1996 doesn't have a conventional speedometer cable.


Why would the speedometer and cruise control stop working the same time as the OD light began flashing on my 1996 Mystic?

Your speed sensor probably broke and needs to be replaced. If the car can't determine it's speed, then it may automatically disable the cruise control.


How do you change a speed sensor on a 1996 subaru legacy and the location?

i found mine it is on the left side in the back of the engine on top of the trans