To change the heater motor on a Vectra C, first, disconnect the car battery for safety. Remove the glove compartment to access the heater motor, then disconnect any wiring and screws securing the motor in place. Replace the old motor with the new one, reassemble everything, and reconnect the battery. Test the heater to ensure it is functioning properly.
no you have to remove all of it remember to mark the motor shaft and linkage positions
In a Vauxhall Vectra C, the heater resistor is typically located behind the glove compartment. To access it, you may need to remove the glove compartment and possibly some trim panels. The resistor is connected to the blower motor and controls the fan speeds for the heating and ventilation system. Always consult your vehicle's service manual for specific instructions and safety precautions.
To change the heater matrix unit on a Vauxhall Vectra C, you need to start by disconnecting the battery and removing the dashboard to access the heating system. Drain the coolant and remove the hoses connected to the heater matrix. Then, detach the heater matrix from its housing, replace it with the new unit, and reassemble everything in reverse order, ensuring all connections are secure before refilling the coolant and reconnecting the battery. It's recommended to consult a service manual for detailed instructions specific to your model.
how do you change vauxhall vecta c heater sensor
Continental/VDO New A/C Heater Blower Motor PM4820
The a/c heater blower motor for the front unit is located at the rear right side in the engine compartment behind the air duster......... The a/c heater blower motor for the rear unit (if equipped) is located in the rear a/c housing below the armrest..........
Will a tow bar of a vectra b fit a vectra c
vectra b is the earlier engine
there a temp. control motor that control the a/c & heater replaced motor price is about $184.50 for the part
first you will have to remove your heater hoses going to your motor to the firewall take them off at the firewall, then there is a big box on your firewall, there is a bunch of screws holding it on remove them you heater core will be inside it.
i will let you know,,have brought a second hand wiper motor which i intend to fit tomorrow Saturday,, i will let you know how i get on?
Probably not has they never work. On vectra b theres a nut under the handbrake gattor, not sure if its same on vectra c