answersLogoWhite

0

What else can I help you with?

Related Questions

How do you change a clutch cable on a 1998 integra?

You don't. There is not a clutch cable on a 1998 integra. It has a hydraulic clutch.


How do you change the shifter cable on a 1998 oldsmbile silhouette?

To change the shifter cable on a 1998 Oldsmobile Silhouette, first you need to disconnect the cable from the shifter, then disconnect it from the engine's control arm. Then replace it with the new cable and make sure it is functioning.


When was Accelerator - Royal Trux album - created?

Accelerator - Royal Trux album - was created on 1998-08-21.


How do you change the antenna cable on a 1998 buick lesabre limited?

To change the antenna cable on a 1998 Buick LeSabre Limited, a person has to unscrew the old antenna cable from the back of the radio. Then pull the antenna wire out from under the dash and follow it to the antenna. Unscrew the old cable from the antenna. Screw in the new cable and thread it back under the dash in the same path as the old cable and screw it to the back of the radio.


How do you change positive battery cable in a 1998 Cherokee sport?

To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.


Where is the overdrive sensor on 1998 Isuzu NPR?

The sensor will be by the accelerator pedal


Does 1998 Honda Prelude have a clutch cable?

Does a 1998 Honda prelude have a clutch cable


When did Northern Cable end?

Northern Cable ended in 1998.


How do you change shifter linkage 1998 automatic cavalier?

To change the shift linkage in an 1998 automatic Chevy Cavalier the shift linkage needs to be removed from the transmission and pulled from the cabin. The job requires removing the floor console to access the cable. After doing the so the cable can be snaked from inside the cabin, the install is the reverse of the removal.


What could cause hesitation when stepping on accelerator pedal in a 1998 Mazda B2200 pickup?

My 89 B2200 does this. Its like there is a dead spot in the acceleration. It is because the accelerator pump is leaking.


What is the problem with a 1998 911 Carrera if the RPMs are revving up unusually high when you hit the accelerator?

Perhaps you have not engaged the clutch? The accelerator is designed to increase the RPMs. If you provide no resistance it will rev until it explodes.


How do you change a throttle position sensor on a 1998 Bravada?

To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ