0
You need a pump puller, a 13mm wrench, a 21mm wrench, a 30mm wrench and a flat-tip screwdriver. Parts include a pump, an overhaul gasket set (cheap, and contains LOTS of handy gaskets) and some anaerobic sealant. In the overhaul kit you will find two square paper gaskets with holes in the corners. Extract them and set them close to hand. You also need three quarts of oil.
Quick steps:
-
Remove fan belt (21mm wrench on generator pulley nut) and crank pulley (30mm wrench). Remove the two pieces of tin at the back of the engine and drain the oil.
-
Once all the stuff in step 1 is done you'll see a square metal plate with four 13mm nuts holding it on. That's the oil pump cover. Remove the nuts and pry off the cover, then remove the gears with your fingers (they slip right out) and use the puller to extract the pump case. Note how it's in.
-
Clean the mounting area on the engine case and the back of the oil pump cover, being sure to remove any sealant that might still be there. Spread a little anaerobic sealant on both sides of the gaskets. Put a gasket over the four bolts. Slip the oil pump body over the bolts the same way the old one was in. Put the second gasket on, then the pump cover. Install the nuts and tighten to 25 lb-ft. Put two and a half quarts of oil in the engine.
-
Reinstall what you removed in step 1, and you're done.
What else can I help you with?
Oil change on a 2008 VW Beetle?
where is the oil filter on a 2008 vw beetle
How do you reset oil light on a 2013 Volkswagen beetle?
how to reset change oil message on 2013 beetle
How do you change the oil pump in a Kia Sportage?
Oil pump change
Where is the oil pressure light on a 1968 VW beetle?
left side of speedo
How can you prevent the gasoline from siphoning into the oil on a 67 VW Beetle?
replace the fuel pump.
How do you change the oil pump in a S10 pickup 1991?
how do you change the oil pump on a 1991 s10 pickup
How do you change oil pump on 1999 plymouthy neon?
Answering "How do you change oil pump on 1999 plymouthy neon?"
How do you change oil pump in holden vectra 2000?
The oil pump is located inside the oil pan. You have to drop the oil pan to replace the oil pump.
How do you change oil pump on a 2002 crown Victoria?
Have to remove the oil pan to get to the pump.
How do you change a oil pump in a H2?
To change an oil pump on a H2 you need to first drain the oil from the H2. Once the oil pan is empty, drop the pan in order to reach the oil pump. Remove the bolts and disconnect the hoses on the oil pump and replace with the new one.
Superbeetle oil change?
If your asking how often you change the engine oil it is suggested at 3000 miles (4800 Kilonmeters) on a STOCK non-oil filter beetle.
Where is the oil pump on 2003 expedition?
the oil pump is in the oilpan but in order to change it you will have to to the timing as well
