answersLogoWhite

0

To check the transmission oil in a Porsche 944, first ensure the vehicle is on a level surface. Start the engine and let it warm up so the oil reaches optimal operating temperature. Locate the transmission dipstick (if equipped) or check the fill plug on the side of the transmission; remove it carefully and use your finger or a dipstick to check the oil level. If needed, add the appropriate type of Transmission Fluid until it reaches the correct level.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How do you do a tune up on a 1987 Porsche 944 NA?

spark plugs and wires, oil and oil filter, air filter, check rotor and points in distributor, check belts, just basic maintenance.


What is the oil capacity of a 1985.5 Porsche 944?

5 quarts without a filter, 5 1/2 with.


Where is the 944 Porsche oil pressure sensorlocated?

The oil pressure sensor on a Porsche 944 is typically located on the engine block, near the oil filter. It is mounted on the lower part of the engine, often on the driver's side, and can be accessed from underneath the vehicle. To identify it, look for a small cylindrical component with an electrical connector attached.


How many quarts to refill transmission oil Porsche 944?

2 liters, so just a tad more than 2 quarts. The fluid level should be 6-8mm below the filler hole.


Is there a transmission dip stick located anywhere on my 1999 Porsche boxter so I can check my oil level?

Yes there is on all cars.It should be on the side of your oil


Recommended motor oil for 1985 Porsche 944?

I use Mobil 1 10w30 works well with good quality filter.


What motor oil recommended for 1983 944 Porsche?

For a 1983 Porsche 944, it's generally recommended to use a high-quality synthetic oil with a viscosity of 10W-40 or 20W-50, depending on the climate and driving conditions. Many enthusiasts prefer synthetic oils due to their better performance and protection at high temperatures. Always check the owner's manual for specific recommendations and ensure the oil meets the API (American Petroleum Institute) standards for that model.


How do you change the oil pressure switch on a 1984 Porsche 944?

To change the oil pressure switch on a 1984 Porsche 944, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the oil pressure switch on the engine block, usually near the oil filter, and remove the electrical connector. Use a socket wrench to unscrew the old switch, then install the new switch by threading it in and tightening it securely. Finally, reconnect the electrical connector and the battery terminal before starting the engine to check for leaks.


Where is the oil drain plug on a 944 Porsche?

the oil drain plug is located at the bottom of the sump under the engine. If memory serves you will need a hex bit to remove it.


What is the oil capacity of a 1990 Porsche 944 s2?

6 quarts U.S. Dash warning indicator will light up with 5 quarts.


What is the transmission oil capacity on a 2001 Porsche 996 with a six speed?

Roughly nine quarts. Be sure to wait for the ten minute countdown to complete after first starting the car to check the oil level on your dipstick. Porsche Technician Birmingham, Alabama


Where is the oil pressure sender unit locoated on a Porsche 944?

It is located just below where your oil filter and just above where you power steering pump are mounted in the engine compartment.