You can disable the light, but the problem is probably caused by dirty wheel speed sensors. They are very easy to clean. It only takes about half an hour. Here are instructions on how to do it.
http://www.jaguarforums.com/forum/xk8-xkr-17/how-cleaning-wheel-speed-sensors-faq-37434/
You can't. It is most likely a faulty abs sensor. they are easy to replace and you can pick one up on eBay for under £40
The ABS light is on because there is a problem with the ABS. The light won't go out until the problem is fixed. As long as the ABS light is on the ABS will not function.
The abs light is on because there is a problem with the abs system. Until the problem is fixed the light will remain on.
how to reset abs warning light on 2000 gmc Yukon
How do you disable the abs on 2008 yaris
If you want to just disable the ABS then you can pull out the fuse for the ABS relay. The only thing is the ABS light will show on the dash.
remove the fuse or relay is the easyest way but the abs light will be illumeinated very annoying.
Why would you want to disable the ABS?
To disable the ABS on a 2000 Mercury Mountaineer, you can remove the ABS fuse from the fuse box. The specific fuse to remove is typically labeled as "ABS" or "Anti-lock Brake System." Check your owner's manual for the exact fuse location and number. However, it's important to note that disabling ABS may affect vehicle safety and handling, so proceed with caution.
You cannot do it yourself unless you have a scantool.
at the abs pump. you brakes will now react normally, but your abs light will stay on
The abs light is on because there is a problem with the abs system. Have the system repaired and the light will clear itself.