To disconnect the anti-theft fuse on a 1999 Volvo V70, locate the fuse box, which is typically found under the dashboard on the driver's side. Use the fuse diagram found on the cover of the fuse box to identify the specific anti-theft fuse (usually labeled as "alarm" or "anti-theft"). Carefully remove the fuse using fuse pullers or pliers, ensuring the ignition is off to avoid any electrical issues. If you're unsure, consult the owner's manual for detailed instructions or seek assistance from a professional mechanic.
Try to disconnect the battery for a few minutes.
hi, disconnect the battery for 5 minutes.
Disconnect the red battery wire then reconnect it.
disconnect the battery for 1min or so the light will go off
10mm socket and bullnose pliers, disconnect the battery first!
Disconnect the battery for 5 minutes get the radio code before doing this
Disconnect the red battery cable. Wait a few moments and reconnect it.
Sure just observe safety. Disconnect negative cable first and connect it back last.
I just disconnect the battery terminal for a few minutes and then connect it again and the Lambda light goes off. Emmanuel Vella.
I need a new battery for a 2007 Volvo S40 what are the specifications ?
To change the headlight socket on a 2000 Volvo V40, first, disconnect the negative battery terminal to ensure safety. Remove the headlight assembly by unscrewing the retaining screws and pulling it out. Then, disconnect the old socket from the headlight bulb and replace it with a new socket by securing it in place. Reassemble the headlight assembly, reconnect the battery, and test the new socket to ensure it works properly.
Step One - Disconnect Battery. Step Two - Disconnect Battery. If you do not disconnect battery you will have to take the car to the dealer so they can charge you 100 bucks to reset the SRS airbag reset light. Volvo is evil. Step Three - "POP-UP" plastic surrounding gear shift using screw driver or credit card. Step Three - There will now be two "star" screws exposed. Unscrew both. Don't drop screws inside. Step Four - Pull unit down and towards you. Also, gentle wiggling from side to side helps Step Five - Disconnect Wires.