answersLogoWhite

0

Same as you do on every other car, bleed the brakes fully and replenish

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the brake fluid in an Vauxhall meriva?

In the brakes.


What brake fluid does a vauxhall corsa use?

Dot 4


Do you need to drain brake fluid when changing brake pads and rotors?

no


Which brake fluid should you use for a 1977 vauxhall vx2300?

In my manual for the Vauxhall VX 2300, year 1977, it says that the right Brake Fluid is of the type GM-4653-M. Trouble is that I can not find out on the internet weather this is Dot 3 or Dot 4 Brake Fluid (DOT 5?)...... Would be nice if someone did have that answer. zwets_@hotmail.com


Where to put clutch fluid in Vauxhall vectra?

You top it up via the brake master cylinder.


Where is brake fluid sensor on Honda. My brake light comes onoff and fluid is full and emergency brake is not on. What is it?

I have the same problem - I was recommended a brake fluid drain and brake fluid sensor replacement - haven't done it yet, but hopefully it works. Dealer quoted me $190.


How do you change the brake fluid on a 2004 VW Passat 4 motion wagon?

you have to bleed or drain the fluid


Why your brake pedal is too hard to push in a 1995 ford taurs?

you probably need to change the brake fluid drain it then put new fluid


What does it mean on a 1996 vauxhall corsa when the handbrake warning light is always on?

this also illuminates when brake fluid is low either your brake pads are worn out or you have a leak


Where do you put brake fluid in a 2001 vauxhall zafira 2 liter dti?

it should be on the drivers side under the windscreen


What type of brake fluid is used in vauxhall corsa 2003?

The 2003 Vauxhall Corsa typically uses DOT 4 brake fluid. It's important to check the owner's manual or consult a mechanic to confirm the correct type for your specific model, as requirements may vary based on the vehicle's braking system. Always ensure that the brake fluid is in good condition and replaced as needed to maintain optimal braking performance.


How do you bleed the clutch on a Yamaha royal star 1300?

To bleed the cluth on a Yamaha Royal Star 1300 first drain all of the brake fluid from the vehicle. After draining the brake fluid pump the brake pedal up and down several times. All oil will then drain from the system.