To drain coolant from a W-reg Vauxhall Corsa, first ensure the engine is cool and then locate the radiator drain plug, typically found at the bottom of the radiator. Place a container underneath to catch the coolant, then open the drain plug and allow the coolant to flow out completely. Additionally, you may also remove the expansion tank cap to facilitate the draining process. Once drained, close the drain plug, refill with new coolant, and check for any leaks.
To drain the coolant system on a 98 Corsa, locate the drain plug under the radiator. Remove the plug and catch the run-off in a pan.
WREG-TV was created on 1956-01-01.
my drain is brok and i casn not get it out how can i drain the coolant?
To drain the coolant on a Mazda 626, locate the drain plug on the bottom of the radiator. Remove the plug and drain the coolant into a pan.
Assuming there is coolant in the engine the most likely cause is a build up of sediment behind the coolant drain or in the coolant drain tap itself.
To replace the thermostat on a Corsa 1.4, first ensure the engine is cool and disconnect the battery. Remove the coolant reservoir and drain the coolant from the system. Locate the thermostat housing, typically near the engine block, and unbolt it to access the thermostat. Replace the old thermostat with a new one, ensuring the rubber O-ring is properly seated, reassemble the housing, and refill the coolant before reconnecting the battery.
To drain the coolant from a 2002 VT750DC Shadow Spirit, first ensure the engine is cool. Locate the coolant drain bolt at the bottom of the water pump or the radiator, depending on your configuration. Place a container underneath to catch the coolant, then remove the drain bolt and allow the coolant to flow out completely. After draining, reinsert the drain bolt and refill the system with fresh coolant.
To drain the coolant from your Polaris ATV, first ensure the engine is cool and locate the drain plug, typically found at the bottom of the radiator or engine block. Place a drain pan underneath to catch the coolant, then remove the drain plug and allow the coolant to fully drain out. After draining, replace the drain plug securely and refill with the appropriate coolant mixture as specified in your owner's manual. Always dispose of the old coolant responsibly, as it is toxic to pets and wildlife.
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
To drain the coolant on a 2009 Range Rover with a turbo, first ensure the engine is cool, then locate the coolant drain plug, usually found at the bottom of the radiator. Position a drain pan underneath, remove the drain plug, and allow the coolant to flow out completely. After draining, replace the drain plug securely and refill the system with the appropriate coolant mixture. Always dispose of the old coolant properly and check for leaks after refilling.
there is a drain plug/petcock in one of the corners on the engine side of the radiator. you just have to open that and the coolant will drain out. remember coolant is hazardous to pets as well as the environment.
To drain coolant from a RZR 800 motor, first ensure the engine is cool and the vehicle is on a level surface. Locate the coolant drain plug, typically found on the engine block or water pump, and place a container underneath it to catch the coolant. Remove the drain plug carefully to allow the coolant to flow out, and be sure to dispose of the coolant properly. After draining, replace the drain plug securely before refilling with fresh coolant.