Most cars have a switch to disable the cruise control. To permanently disable the cruise, remove the fuse for the circuit.
Remove the battery and the cruise control actuator. The starter has two bolts holding it in. Remove the bolts and wiring, then install the new starter. Re-install the cruise control and battery.
To change the heater control panel on a Mercedes C180, remove the radio and the two screws under the CCU panel. Pry off panel and remove the bracket.
In the 2003 Mercedes E320, the amplifier is typically located in the trunk, specifically on the right side behind the side panel. To access it, you'll need to remove the trunk liner or side paneling. The amplifier is usually mounted to the body of the vehicle and may be secured with screws. Ensure the vehicle is turned off and disconnected from power before attempting to access it.
explorerforums.com has a great walk thru
Cruise control
There is a fuse located behind the battery. You will have to remove a plastic shield that runs behind the battery first. You will then find a round fuse holder with a single fuse in it. Check and replace if burned out , this is the most likely cause.
In the 1997 Mazda Millenia, the climate control amplifier is located behind the dashboard, specifically on the passenger side. To access it, you typically need to remove some trim panels and possibly the glove compartment. The amplifier is responsible for regulating the climate control system, including the operation of the air conditioning and heating.
what happens if we remove Rc in RC coupled amplifier
If you are talking about the radio, the amplifier is built in.
under the dash, look up on the left (driver's side) of the steering column. It will have a brown connector plugged into it. If you have cruise control, the cruise control box is covering it up. Remove the bolts (10mm socket) in the cruise control box and you will expose the "PGM-FI Relay". You will need a 10mm deep socket to remove the nut holding the relay in place.
In a 2005 Mercedes CLK 320, the audio amplifier is typically located in the trunk area, specifically on the right side behind the side panel. To access it, you may need to remove the trunk liner or side trim panel. This location allows for efficient sound processing and power distribution for the vehicle's audio system.