To get the cable outer free of the bulkhead you need to work inside the car - the cable is a tight snap fit in the hole with plastic "barbs". I cut a notch in the surrounding rubber gasket so that I could see the end of the cable outer. Then use a pin punch and a hammer to free the cable from the hole. I broke off one of the barbs which is of no consequence on the old cable. As you have discovered, there is no access under the bonnet due to the steering rack.
The real joker with this job is access to the top of the clutch pedal to release the spring clip to enable the plastic end of the new cable to be hooked in (this is where they always break). Unless you are Houdini, take the nut off the clutch pedal pivot bolt, get an assisant to open a brake bleed nipple and lower the brake pedal sufficiently to free the captive pivot bolt. Fitting the new cable inner to the top of the clutch pedal is now "easy". Bleed the brake if you have let any air in, and don't forget to top up the fluid. To get the new cable outer back in the hole, refit everything and get an assistant to press the clutch pedal whilst you guide the outer into position under the steering rack.
I replaced an auto-adjust cable with a manual adjust type from a motor factor - very cheap. Beware, there are two patterns of cable with differing bulkhead fittings, both are available. The manual adjust cable has been no problem in use and requires very little adjustment, just make sure there is a little free play at the pedal. Best of luck; it's easier than it sounds when you've done one, and mind your back!
To fit the clutch cable onto the back of the pedal on a Peugeot 106, first, ensure the vehicle is in a safe position with the ignition off. Locate the clutch pedal and identify the attachment point for the cable, which is typically a clevis or a hook. Carefully thread the cable through the pedal assembly and secure it by either pushing it onto the clevis or connecting it to the hook, ensuring it is properly seated. Finally, check the cable tension and make any necessary adjustments to ensure smooth operation.
How to fit clutch cable on a daewoo cielo
No
yes
no
Yes, as long as your wheels are 4 stud. Some peugeot 106 models are 3 stud.
yup.
Yes!
its hydraulic not cable
You should be able to but you will need new mounts and some links.
yes :P
Should fit pretty much as is, might need to change / up grade mounting bushes/components. don't forget the ecu's tho....