answersLogoWhite

0

To replace the clutch on a 106 you will need to remove the air box, battery, wheels and starter motor and disconnect the gear linkages. Before you remove the drive shafts drain the gearbox vie a 3/4 square drive plug located on the bottom of the gearbox (then remove the shafts).

After this you will need to support the engine and remove the engine mount from the gearbox.

Once this is done the electrical cables connectors and associated clips will have to removed from the gearbox.

Once you are sure that there is nothing left fastened to the box remove the gearbox bolts including the bolt located under the engine that secures the front pipe to the engine/gearbox.

The gearbox should then be removed by sliding it slightly to the N/S of the car to extract the input shaft from the crank and then lowering to the floor,

The clutch is then visible and can be replaced ensuring that the clutch is tightened evenly and properly aligned using the appropriate aligning tool (sometimes supplied with the new clutch).

Before refitting the gearbox it is always worth replacing the driveshaft oil seals on the gearbox as these can be a pain if they leak once the job is complete.

Refit the box and reassemble the components in reverse order remembering to refill the box with fresh gearbox oil

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Will a transmission from a 1989 Mustang fit in a 1989 Lincoln Mark VII?

It is possible that a Mustang transmission will fit in a Lincoln Mark VII. It is likely that the clutch plate and the pilot bearing will have to be changed.


How do you fit clutch cable?

How to fit clutch cable on a daewoo cielo


How do you fit the clutch cable onto the back of the pedal on a peugeot 106?

To fit the clutch cable onto the back of the pedal on a Peugeot 106, first, ensure the vehicle is in a safe position with the ignition off. Locate the clutch pedal and identify the attachment point for the cable, which is typically a clevis or a hook. Carefully thread the cable through the pedal assembly and secure it by either pushing it onto the clevis or connecting it to the hook, ensuring it is properly seated. Finally, check the cable tension and make any necessary adjustments to ensure smooth operation.


How many 2 nanometers could fit into 2 millimeters?

1 millimetre = 106 nanometres so 106, or a million will fit.


Fit corsa clutch master cylinder?

consentric clutch type


Will 306 seats fit 106?

Yes, 306 seats will fit 106 people. In fact, it means there will be an excess of 200 seats available. Therefore, there is ample capacity for the 106 individuals.


Will peugeot 306 wings fit on a 106?

no


Will a 106 exhuast fit a 1.4 saxo?

If it's off of a similar aged 106 1.4 it should fit. 1.0 & 1.1 may not though


How do you change dirt bike clutch?

how do i fit a clutch on my grizzly 12 dirt bike


Will the clutch from a 350 fit a 396?

Yes.


Does anyone no if a 306 engine will fit in a 106?

nooooooooooooooooooooooooooooooo


How many hours to fit clutch TOYOTA GT4?

about 6 hours depend what kind of clutch it is