answersLogoWhite

0

Requires a special wrench tool.

Look on eBay for "Volvo Oil Filter Wrench"

They are about $10.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you turn off driving lights on Volvo xc90?

The driving lights on a Volvo xc90 are turned off by turning the knob on the left side of the steering column. Driving lights are used to notify other driver's of the vehicle's presence.


How do you turn off tailgate light on 2007 Volvo XC90?

It is on a timer; just give 10 minutes or so, and it will shut off.


How do you regenerate a full soot filter on a Volvo xc90?

To regenerate a full soot filter on a Volvo XC90, the vehicle typically initiates an automatic regeneration process while driving at higher speeds, which raises the exhaust temperature and burns off accumulated soot. If the filter is still full after regular driving, you may need to use a diagnostic tool to force a regeneration cycle. Additionally, ensure that the diesel particulate filter (DPF) pressure sensor is functioning correctly, as issues here can prevent regeneration. Regular maintenance and using the appropriate fuel can help minimize filter clogging.


How many gallons of gas does a Volvo XC90 hold?

Well, honey, a Volvo XC90 typically holds around 18.8 gallons of gas. Just enough to get you where you need to go without stopping too often. Unless you drive like a maniac, then all bets are off.


How do you reset service light Volvo Xc90?

To reset the service light on a Volvo XC90, start by turning the ignition to the "ON" position without starting the engine. Press the brake pedal and then press the gas pedal three times. Next, turn the ignition off, and then turn it back to the "ON" position again. The service light should now be reset.


How do you drain the oil on a 2008 Volvo xc90?

To drain the oil on a 2008 Volvo XC90, start by warming up the engine slightly to thin the oil for easier drainage, then turn it off and allow it to cool a bit. Place a drain pan under the oil pan, remove the oil drain plug with a wrench, and let the old oil flow out completely. Once drained, replace the drain plug securely, and refill with new oil through the oil fill cap. Always dispose of the old oil properly at a recycling center.


Reset oil change indicator on 2005 Volvo xc90?

To reset the oil change indicator on a 2005 Volvo XC90, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After this, turn the ignition off and then start the engine to verify that the oil change indicator has been reset. If the light remains on, repeat the procedure.


How do you get the oil filter cap off a 2002 Pontiac sunfire if the cap is stripped?

It sould just pop off like a plug in a wine bottle.


Where is oil filter located 2004 Pontiac Sunfire?

The Oil Filter is on the top of the engine, to the left of the valve cover. It has a plastic cap that can be wrenched off. The Oil Filter is not a sealed filter that you are used to seeing. It drops in where you removed the black cap.


How do you jump start xc90?

To jump-start a Volvo XC90, first ensure both vehicles are turned off. Connect the positive (red) jumper cable to the dead battery's positive terminal and the other end to the donor battery's positive terminal. Next, attach the negative (black) cable to the donor battery's negative terminal and the other end to a grounded metal part of the XC90, away from the battery. Start the donor vehicle, then attempt to start the XC90.


Where is the oil filter on a 07 f350 6.0?

On top of the engine right in the center, under the black cap which screws off, the other black cap next to it is the secondary fuel filter.


How do you take off distributor cap from a 1991 740 volvo?

To remove the distributor cap from a 1991 Volvo 740, first ensure the engine is off and disconnect the negative battery terminal for safety. Then, carefully detach the ignition wires from the cap, noting their original positions for reinstallation. Use a screwdriver to remove the screws or clips securing the distributor cap and gently lift it off the distributor. Be cautious not to disturb the rotor underneath, as it should remain in place.