answersLogoWhite

0

To install rubber in the window of a 1972 Volkswagen Beetle, first, remove the old rubber and any debris from the channel. Then, use a lubricant like soapy water to help slide the new rubber seal into place. Start at one corner and work your way around, ensuring the rubber is seated evenly in the channel. Finally, press the glass into the rubber and secure it with any necessary clips or trim pieces.

User Avatar

AnswerBot

5d ago

What else can I help you with?

Related Questions

What it is called a part of the window that makes the window glass of Volkswagen new beetle goes up and down?

what it is called a part of the window that makes window glass of Volkswagen new beetle goes up and down?


Was there a kit to remove the split rear window from the volkswagen beetle?

Not that I'm aware of.


How can I tell if my window regulator is broke on 2000 vw beetle?

You can tell if your window regulator is broken on a Volkswagen Beetle when you hear a big clunk as it goes down.


How do you install windows in a 1974 VW beetle?

To install windows in a 1974 VW Beetle, start by ensuring the window frames are clean and free of rust. Apply a bead of automotive sealant or adhesive around the window opening, then carefully position the window into place, ensuring it fits snugly. Use rubber seals or gaskets as needed, and secure the window by reinstalling any retaining clips or trim. Finally, check for proper sealing and make any necessary adjustments.


What year vw beetle came with a rear split window?

Volkswagen Ran with the split-window from 1938-1945 (KDFWagen) And from 1945 Until March of 1953 when they changed the design to the oval window. Regards.


How do you replace the window regulator on 2003 volkswagen beetle convertible rear power window?

Follow the instructions on the link below. If you take your time and have patience, it isn't too bad. http://www.denlorstools.com/autoblog/2008/10/new-beetle-quarter-window-replacement-auto-tools/


How do you install a new window crank on an old Volkswagen?

There is a Phillips head screw under the plastic cover.


When did the Volkswagen Beetle first appear in the US?

1949.The first Volkswagen Beetles were officially imported to the US in 1949. That year, there were two Volkswagen Beetles sold. These were the models with two half-circle rear windows, also known as the Split-Window Beetles.


What are the dimentions of a 1973 super beetles rear window?

The rear window of a 1973 Volkswagen Super Beetle measures approximately 33 inches wide by 16 inches tall. This larger, curved window design was one of the distinguishing features of the Super Beetle compared to earlier models. It provided improved visibility and a more modern aesthetic for the vehicle.


Volkswagen passanger side gets wet when it rains?

Assuming that the window is rolled up, you must have a bad rubber door seal on the passenger side.


How do you install the left rear window on a 68 beetle I have the rubber gasket?

Put the gasket on the new window. Put a small diameter rope or cord in the channel with a foot or two extra to pull on later. Put window in the opening on the outside of car. Have someone hold window firmly in place. Pull on the cord from inside the car and work the gasket into place. It helps to put powder or wd-40 on gasket to make it slip into place easier.


How many different Volkswagen Beetle body styles have been made?

The Volkswagen (literally, "people's car") Beetle was first produced in 1938. Since then, over 21,000,000 have been made. Only 2 different body styles have been offered. Coupe, and convertible. The coupe in some years had a split rear window, and some years also saw rear seat windows.