the starter motor is located in the middle of the rear side of the engine above the gear box.
to remove it you will need to remove a 17mm retaining nut positioned below the starter another at the top, it's hidden under a wiring loom so have a good look round.
then remove the wires from the motor with a 13mm spanner.
although it is tight you then remove the whole thing from the underside of the engine.
hope this is of use to you ....
To change the starter motor on a Vauxhall Frontera 2.5 TDS, first disconnect the negative battery terminal to prevent electrical shorts. Remove the heat shield if applicable, then locate the starter motor, which is typically mounted on the engine block. Disconnect the electrical connections and the mounting bolts, then carefully remove the old starter motor. Install the new starter by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.
To remove the starter motor from a 2002 Vauxhall Combo, first disconnect the battery to ensure safety. Then, locate the starter motor, which is typically situated near the transmission. Remove any mounting bolts securing the starter, and disconnect the electrical connections, taking note of their positions. Finally, carefully pull the starter motor out of its housing.
The starter solenoid is located on the starter. It would be more cost-effective to have the entire starter replaced with a good remanufactured unit on this application.
Almost all starter solenoids are directly attached to the starter. It is a much smaller "bump" ont he starter with wires normally attached to it.
Unhook your battery, locate your starter........ which should be behind A/C compressor there are 4 bolts, two in the front and two behind the starter.
On a Vauxhall Corsa 1.2 (X reg), the starter motor is typically located on the lower side of the engine, near the transmission. It is positioned close to the flywheel and is accessible from underneath the vehicle. To reach it, you may need to lift the car and remove any protective covers or components that obstruct access.
To change the starter on a Kawasaki Mule 2510, first disconnect the battery to ensure safety. Remove the starter cover and locate the starter motor, then disconnect the wiring harness and the mounting bolts securing the starter in place. Take out the old starter and replace it with the new one, reattaching the bolts and wiring harness. Finally, replace the starter cover and reconnect the battery.
where is the starter locate on 1997 grand am
1.Disconnect negative battery cable. 2. Climb underneath and locate the starter. 3. Disconnect cables and wires on starter. 4. Remove bolts holding starter in place. 5. Remove starter. Installaton is REVERSE of removal
where is the starter locate on a 2007 525i BMW
Not wishing to be rude, but if it is not obvious to you, perhaps you should not be tmepted to touch it. On smaller engined models it is at the rear of the engine, driven by the belt and to remove it you need to approach it from underneath and preferably having removed the starter motor.
where is the starter locate on a 2007 525i bmw