answersLogoWhite

0

# Disconnect the battery. You don't want to pop the airbag accidentally. They are expensive, and if you are sitting in front of it when it goes off it will hurt. # Remove the four Torx screws holding the airbag to the wheel hub. # Lift off the airbag. Be careful not to stretch springs and wires. # Disconnect the airbag and horn connectors. # Pry the circlip off the steering shaft. # Unscrew the big nut. # Use a steering wheel puller to get the wheel off. Remember the position, it's important. # Use a lockplate removal tool to depress the lockplate. # Pry off the lockring.

You should be looking at the turn switch now.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace the turn signal switch located on a 1998 Chevy Lumina?

pull the steering wheel


How do you remove steering wheel Chevy lumina 2000?

How to remove steering wheel on Chevy lumina 2000


How do you replace the turn signal switch on a 2001 Yukon?

You need to remove the steering wheel. The switch is located below the steering wheel.


How do you replace steering wheel control light in Silverado?

Have to replace the whole switch


Why don't i have no brake lights on my 1995 Chevy lumina come on except for the one in the window?

I had the same problem in my '97 Lumina. There is an actuator switch in the steering column that was bad. I was going to replace it myself but the covers for the steering column required that the steering wheel be removed and I didn't have the tools so I had to take it to the garage and have them replace the actuator. Hope this isn't too late to help


How do you replace a turn single switch in a 1996 Chevy Lumina LS with a air bag the only why the blinker works is if you hold the switch?

Its a tough job that requires special tools. Remove the air bag. Remove the steering with a steering wheel puller. Remove the air bag position sensor. The steering wheel lock plate needs to be removed with a steering wheel lock plate puller. Then the turn signal switch can be removed by snaking the wire harness through the steering column. Not as easy as it sounds.


How replace turn signal switch 98 camaro?

You will have to pull the steering wheel off to get to the switch, after the wheel is off take top cover off steering column and you will see how the switch bolts in.


What could be wrong with a 1992 Lumina if the hazard lights work but not the signals?

your flasher is bad replace it It's probably the turn signal signal switch in the steering wheel hub. They're junk from the factory.


Why is it NECESSARY to remove the steering wheel to replace the ignition switch on a 1994 Ford Explorer?

I was under the impression the switch was on the steering column about 18 inches from the floor. The lock assy is under the steering wheel.


How do you replace light on button on steering wheel on duramax diesel?

Most steering wheel buttons bulbs are not serviceable, you must replace the button(switch) or the shole horn pad, most dash and switch bulbs are not serviceable


How do you replace the ignition switch in a 1990 Chevrolet Corsica with tilt wheel?

The switch is on the steering column about 18 inches from the floor. Simply take 2 screws holding it on and replace it.The locck cylinder is under the steering wheel.


How do you replace cruise contol switch on 96 corsica?

To replace the cruise control switch on a 1996 Chevrolet Corsica, first, disconnect the negative battery cable to ensure safety. Remove the steering wheel by taking off the retaining nut and using a steering wheel puller if necessary. Once the wheel is off, access the cruise control switch by removing the screws or clips securing it to the steering column. Finally, replace the old switch with the new one, reassemble the steering wheel, and reconnect the battery.