answersLogoWhite

0

The rear disc break pistons on Mazda are not to be pushed in. Instead you turn them in clockwise.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

02 Mazda pro 5 e brake cable loose?

HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?


How do you get piston in rear brake caliper to retract back into the caliper so you can change pads on a 2002 Mazda protege 5?

There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.


How do you replace the brakes on a 2002 Mazda Protege EX?

To replace the brakes on a 2002 Mazda Protege EX, start by lifting the vehicle and removing the wheel to access the brake assembly. Unscrew the caliper bolts, then carefully slide the caliper off the brake rotor and support it without stressing the brake line. Remove the old brake pads, install the new pads, and compress the caliper piston if necessary. Finally, reassemble by sliding the caliper back over the new pads, tightening the bolts, and replacing the wheel.


Would the headlights on a Mazda Protege 2002 fit the Mazda Protege 5 2002?

Yes they will fit. There is not a difference in part number for a protege or protege5.


Where is the ignition coil on a 2002 Mazda protege?

Where is the igniyion coil on a2002 mazda protege


2002 Mazda protege 5 alternator belt removal?

how do u replace alternator belt on 2002 mazda protege 5 stationwagon


Where is the belt tensioner for a 2002 Mazda Protege?

in your face :)


Will body kits for a 2002-2003 Mazda Protege fit a 2000 Mazda Protege?

no it will not fit.it is not the same lenght and the same height


WHERE IS the pulse generator in a 2002 Mazda Protege?

The pulse generator on a 2002 Mazda Protege is located on the top of the transmission. The pulse generator can be purchased at any auto parts store such as NAPA.


How do you replace third brake light 2002 Mazda Protege?

To replace the third brake light on a 2002 Mazda Protege, first, open the trunk and locate the plastic cover for the brake light assembly. Remove the screws or clips securing the cover, then gently pull it off. Disconnect the old light bulb by twisting it counterclockwise, replace it with a new bulb, and reassemble the cover by securing it back in place. Test the brake light to ensure it's functioning properly.


What weight oil does a 2002 Mazda Protege 5 take?

For a 2002 Mazda Protege 5, the recommended oil is a 10w 30. 5w30 is recommended in temps below 30 degrees f.


Does Mazda have front wheel drive vehicles?

does a 2002 mazda protege have a front wheel drive