It has wrench flats. I think you can rotate it to loosen it.
Remove the wiring harness from your speed sensor. Remove the speed sensor retaining bolts. Reverse the process to install your new speed sensor.
Remove the wheel, remove the brake caliper, remove the brake rotor, disconnect wheel speed sensor from harness. remove the bearing hub, remove the wheel speed sensor from the bearing hub. Reverse order for install.
if your looking for the front abs sensors thay are located in the hubs, and would have to remove front tire, brakes,caliper, and rotor to remove.
If you jack up the right front (passenger side) side of the vehicle and remove the right front wheel, the speed sensor can be seen and reached on the top of the transmission output housing for the right wheel.
Raise the vehicle and locate the speed sensor. Remove the electrical plug. Turn the speed sensor counterclockwise and remove it. Install the new speed sensor.
The speed sensor is on the front passenger side of the car. Loosen the nuts on the wheel, then jack it up. remove the wheel. As you look where the wheel was, to your left is the speed sensor. It is at an angle, angled towards the back of the car. first unhook the wires attached. you can do this by hand. next, remove the bolt that is holding the speed sensor on. I believe it is a 10mm, and you will need a deep socket. once you remove the bolt, the sensor slides right out. Also, make sure you replace the "O" ring on the sensor. this is an easy job.
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
To replace the front speed sensor in a 1993 Volvo 960, first, ensure the vehicle is safely elevated and supported. Locate the speed sensor on the transmission; it is typically mounted near the output shaft. Disconnect the electrical connector and remove the sensor by unscrewing it from its housing. Install the new sensor by reversing the process, securing it in place, and reconnecting the electrical connector.
Follow the wires to direct front center of throttle body,have to remove top,lg black cover
The 1990 Toyota speed sensor is located on the back of the transmission. There also is a speed sensor on the front passenger wheel.
drivers side front, remove the wheel, and you'll see a sensor with a retaining bolt in the transmission housing.