Purchase or borrow the Mercedes cluster removal keys 9 bucks on eBay, and place them in the slots on the side of the cluster and pull the cluster straight out. Takes 2 minutes
Get the cluster repaired in the USA for around $250
numbers 20 , 21, 22 in the underhood fusebox located on the drivers side near the firewall.
First, disconnect the battery ground, and place the steering wheel in the lowest position. Remove the plastic trim on the left side of the light switch, then remove the light switch by pushing the plastic catch to the left of the switch. Remove the trim to the right of the cluster, exposing two screws that are also to be removed. Remove the screws securing the instrument cluster, then tilt the cluster downward to disconnect the electrical plugs. The cluster can now be easily removed by pulling it directly out of the opening.
To change the odometer light in a 2001 Honda Odyssey, you'll need to remove the instrument cluster. Start by disconnecting the negative battery terminal for safety. Then, remove the dashboard trim and the screws securing the instrument cluster. After pulling it out, locate the odometer light bulb socket, twist to remove it, and replace the bulb with a new one before reassembling everything.
depends on the year if you have the trip computer on the dials display then its normally on the far left hand side of the instrument cluster just below 2 other buttons, up and down for the brightness of the cluster etc. mines a 2001 and is in this place...
you cant you have to swap out the whole instrument cluster. I just had the same problem with mine.
You cant Its part of the instrument cluster If you did the engine wont run
To replace the check engine light bulb in a 2001 Pontiac Grand Prix, first, disconnect the negative battery terminal to ensure safety. Next, carefully remove the instrument cluster by unscrewing the necessary screws and gently pulling it out. Locate the check engine light bulb socket on the back of the cluster, twist it counterclockwise to remove, and then replace the bulb. Finally, reassemble the cluster and reconnect the battery.
Yes
how to remove a Mercedes e240 starter motor and which tools
Your dash lights may be in need of replacement... Instrument Cluster Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the cluster opening trim panel. 3. On vehicles equipped with an automatic transmission, remove the loop on the indicator cable assembly from the retainer pin. Remove the thumbwheel bracket screw from the cable bracket and slide the bracket out of the slot in the steering column tube. 4. Remove the instrumental cluster retaining bolts. 5. Pull the instrumental cluster out of the instrument panel. 6. Detach the electrical connectors. 7. Remove the instrument cluster. To install; 8. The installation is the reverse of the removal. 9. Connect the battery cable, and check the operation of all gauges, lights and signals. *** Turn the light bulb housing counter clock wise. Sometimes they are very hard to turn. Don't be afraid to turn them. ***
Sure, as long as the brightness control isn't turned off.
You have to pull the radio trim, instrument cluster trim & top center heat/ac vent. After these are out you can remove the 3- 7mm screws from the back holding the switch in.