0
What else can I help you with?
Do you have to remove the bumper to change a peugeot 106 headlight?
Yes
Peugeot 106 where is the drain plug on the radiator?
yes its on the right hand side at bottom. bleed screw is near cylinder head at back top left corner
Where is the water temp switch on a peugeot 106 quicksilver?
The water temperature switch on a Peugeot 106 Quicksilver is typically located near the engine block, often at the top of the engine or near the thermostat housing. It may be found on the cylinder head or the coolant outlet. To access it, you might need to remove some engine covers or components for better visibility. Always consult the vehicle’s service manual for precise location and instructions.
What torque sould be used on the cylinder head bolts on a peugeot 106 1.0 petrol?
TU9 engine head torques Stage 1. 20Nm Stage 2. + 240 degrees Maximum bolt length is 176.5mm.
Cylinder head torque settings for peugeot 106 1.4?
For the Peugeot 106 1.4, the cylinder head bolt torque settings typically involve a sequence. Initially, the bolts should be tightened to 20 Nm, followed by an additional turn of 90 degrees, and then another turn of 90 degrees. It's crucial to follow the manufacturer's specific tightening sequence to ensure even pressure across the head. Always consult the vehicle's service manual for the most accurate and detailed specifications.
How do you remove door handle Peugeot 106 Tried always but cant do it aaghhh?
on my r reg 106 i drilled out the 2 rivits
Why is my peugeot 106 over revving whilst I'm driving?
because the head gasket has gone
What is the firing order of a peugeot 106 1.1?
The firing order of a Peugeot 106 1.1, which features a four-cylinder engine, is 1-3-4-2. This means that the cylinders fire in the sequence of the first cylinder, followed by the third, fourth, and then the second. This firing order is standard for many four-cylinder engines to ensure smooth operation and balance.
What torque are the cylinder head bolt peugeot 106 11 petrol?
First step 20Nm Second step 240? (if aluminum cast block)AnswerStage 1. 20Nm Stage 2. + 240 Degrees.Maximum head bolt length is 176.5mm.
Dashboard lights on Peugeot 106?
What's the question? Yes, a peugeot 106 has dashboard lights.
How do you change the front lights on a peugeot 106?
you haft to remove the bumper first to get to the bolts holding in the lights
What is the tightening sequence for head bolts on a peugot 106 1.1?
The tightening sequence for the head bolts on a Peugeot 106 1.1 is to begin at 1 and of the head. Move to the opposite end of the head. Alternate back in forth until you reached the middle.
