First drain it by releasing bottom hose,then remove top hose.
Removing the offside intercooler hose is awkward but makes the job a lot easier later due to lack of space.
Remove front grill (torx screws, 2 on top,2 inside grill under headlights & release side clips)
Slide out both clips from lower radiator lugs (from underneath car).may be better done before you drain it.
Remove both headlights (height adjusting motors are a bayonet type push and twist fitting )
Remove temp sensor wires,unclip and move aside fan wiring, one tiny torx screw fastens a wiring harness to the nearside of the radiator,remove this.
Remove the top slam panel (4 bolts) (if you leave the cable attached put ample rags aronud each end to prevent scratching and support it out of your way)
The complete radiator, intercooler and fan assembly can then be lifted out as one and split later, but be warned the original Renault rad is heavy and is best done with 2 people to aviod damage.
I changed mine this March and it cost me £138 delivered from autokool-ltd via eBay (can I say that on here) As I recall that was how I did mine, nothing to difficult apart from getting to the inner font grill screws.
diagram FOR ESPACE 2.2 DIESEL fan belt fitting 2000 reg
To remove the intercooler from a 2000 Renault Espace, first ensure the vehicle is safely elevated and disconnected from the battery. Then, remove any components obstructing access, such as the engine cover and air intake duct. Disconnect the hoses attached to the intercooler, unscrew any mounting bolts, and gently lift the intercooler out of its housing. Finally, check for any remaining connections or brackets before fully detaching it.
To replace the radiator on a 2000 Renault Clio, first, ensure the engine is cool and disconnect the battery. Drain the coolant by removing the drain plug or lower hose, then detach the upper and lower radiator hoses. Remove any mounting bolts or clips securing the radiator, and carefully lift it out. Install the new radiator by reversing the process, ensuring all connections are secure and refill the coolant before starting the engine to check for leaks.
Or remove lower radiator hose
Drain the water from the radiator. Remove the radiator hoses. Remove the radiator stabilizer arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Drain the water from your Mazda Protege radiator. Remove the hoses from your radiator. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Wait for it to fall off. Being a Renault, it shouldn't take long.
In a 2000 Renault Espace, the fuse for the indicators is located in the fuse box, which is typically situated under the dashboard on the driver's side. You can identify the specific fuse for the indicators by checking the diagram on the fuse box cover or in the owner's manual, as it will indicate the correct fuse number and its function. If the indicators are not working, it's a good idea to check this fuse first for any signs of damage or a blown connection.
To access the stereo in a 2000 Renault Espace, start by removing the trim panel around the stereo. Use a flathead screwdriver or a trim removal tool to carefully pry it off without damaging the dashboard. Once the trim is removed, unscrew the mounting screws securing the stereo, then gently pull it out of the dash. Disconnect the wiring harness and antenna cable from the back of the stereo to complete the removal.
Should be at the bottom or rear of radiator or remove lower radiator hose
Drain the radiator, disconnect the hoses from the radiator, remove any shrouds over the top of the radiator, unbolt the radiator, and pull up.
Drain coolant Remove transmission cooling lines Remove upper and lower radiator hoses Remove upper mounting bolts Pull radiator up from support cradle