To remove the door glass on a 1970 VW Beetle, first, remove the door panel by unscrewing any screws and gently prying it off. Next, lower the glass fully and detach the window regulator by unscrewing the bolts. Carefully lift the glass out of the window frame, ensuring you detach any clips or guides. Finally, remove the glass from the door, taking care to avoid any sharp edges.
remove door handles x2 ,crank and lever (2 screws each) remove cards remove the bolts 10mm seen on door connected to regulator. remove regulate remove glass from reg. rev, for back (use caulk to hold glass in reg bottom)
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
Its not as hard as it sounds, but you have to take off the door panel first. Then you loosen the bolts for the window regulator. Then its just working the winow and out. On my 73 super beetle, I fond it easier to remove the small vent window also.
To remove the door windows from a 1970 Dodge Dart Swinger 2-door, first, ensure the window is fully rolled down. Then, remove the door panel to access the window mechanism and any retaining clips or screws. Disconnect the window regulator from the glass, and carefully slide the window out of the door frame. Be cautious to avoid damaging the glass or any surrounding components during the process.
break the glass
Lower the glass, open the door, pull off the arm rest, pull the door panel, remove insulation , remove the inner glass stabilizers, front door-remove the guide slide, support the btm. Of glass, remove the 2 mounting bolts holding glass to the regulator. Tilt glass up and out of door, remove the regulator-door bolts, disconnect the electric wiring connector, remove the regulator thru the door opening.
There are 2 screws on the inside of the door under the door seal, remove and slide the door handle off.
Carefully.
If it has etched the glass,there is no way to remove it.
Remove outer door skin(if you need directions for this try your local library for a service manual)lower window glass remove glass nuts with toolSA9148B push glass up and rotate slightly remove door glass reverse procedure to install glass
To install door glass on a 1970 Dodge Challenger, first, remove the door panel and any hardware obstructing access to the window mechanism. Carefully position the glass into the window channel and secure it with the provided clips or bolts. Ensure it moves smoothly within the track and aligns correctly with the window seals before reassembling the door panel. Finally, test the window operation to confirm proper installation.
To replace the glass in a door, you will need to remove the door from its hinges, take out the old glass, measure the dimensions of the glass, purchase a new piece of glass that fits those dimensions, and then install the new glass into the door frame. Finally, reattach the door to its hinges.